YSH20_Ope_E.pdf - 第43页
1-7 1 Part names and functions 3. Operation panel and data input unit Standard machines are equipped with an operation display , operation panel buttons, a keyboard and a mouse on the front and rear (option) of the machi…
1-6
1
Part names and functions
n
Dipping station
Dipping station
Squeegee
Dipping table
Film pressure setting gauge
Control box
Clamp lever
(Toggle-type)
Locate pin
23107-H0-00
• Film pressure setting gauge
Use this gauge when adjusting the film pressure while moving the squeegee arm up or down.
• Clamp lever (Toggle-type) and locate pin
Use these to position and clamp the dipping station.
• Control box
Use this control box to select manual or auto mode, reset an alarm, or adjust speed.
MANUAL/AUTO : Select manual or auto mode.
SPEED : Select the rotating speed of the dipping table. (6 steps)
SQUEEGEE : Turns the dipping table in MANU mode.
RESET : Resets an alarm.
ALARM : Lights up if for some reason an excessive load is applied to the motor.
ALARM
AUTO/MANU
SPEED
SQUEEGEE
RESET
Control box
23108-H0-00
1-7
1
Part names and functions
3. Operation panel and data input unit
Standard machines are equipped with an operation display, operation panel buttons, a keyboard and a
mouse on the front and rear (option) of the machine, to operate the machine and make data settings. The
functions of these units are explained below.
Operation display
(touch screen is optional)
Mouse
Keyboard
Operation panel buttons
Operation and data input section
23109-H0-00
3.1 Keyboard and mouse
This machine is equipped with a keyboard and mouse as standard features to operate the machine or edit data
settings. To select a menu button or parameter item on the operation screen, click it with the left mouse button.
Mouse holder
Keyboard and mouse
Back of keyboard
Mouse
Loosen this bolt.
Mouse pad
Turning the keyboard
23110-H0-00
c
Store the mouse in holder when not in use or it may drop and be damaged.
1-8
1
Part names and functions
3.2 Operation panel buttons
The operation panel buttons are provided on the front and rear of the machine to run major commands
frequently used to operate the machine. Each button is lit while turned on.
Operation panel buttons
23111-H0-00
n
Operation panel button functions
Button name Use the button to: OFF ON
ACTIVE
Enable other keys. (The front and rear
[ACTIVE] keys cannot be turned on
simultaneously.)
• After machine has started.
• The other table has access
rights to operate machine.
• Has access rights to
operate machine.
READY
Release emergency stop and turn the
servo on.
• SERVO OFF
(Motor power OFF)
• SERVO ON
(Motor power ON)
RESET
Stop automatic operation and return to
standby for board production.
• Machine is in normal operation
or stopped.
• Machine has been reset.
START (green)
Perform component placement
according to board data.
• Machine is stopped.
• Machine is in normal operation.
[Flash]
Pause or step operation
STOP (Red)
Interrupt automatic operation. (Press
START to resume operation.)
• Machine is in normal operation. • Error occurred.
ERROR CLEAR
(Yellow)
Stop buzzer sound and clear error
screen.
• Machine is in normal operation. • Error occurred.
EMERGENCY STOP
Trigger emergency stop. Turn to the
right to release it.
n
NOTE
The [ACTIVE] button is provided on both front and rear (option) panels, but cannot be turned on simultaneously. This
means that the [READY], [START], [ERROR CLEAR] and [RESET] buttons are enabled only when the [ACTIVE] key on the
same panel is turned on. (The [STOP] button can be used when the [ACTIVE] button is either on or off.)
The keyboard is enabled only when the [ACTIVE] key on the front panel is on.