YSH20_Ope_E.pdf - 第30页
3.6 Retry 3-2 1 2 2 3 3.10 Pick Rate W arning 3-2 4 Appendi x A1. Specifications A- 1 Inde x
8
8
2.2 Setup screen 2-11
2.3 Unit screen 2-13
3. Starting and stopping the machine 2-18
3.1 Pre-operation check 2-19
3.2 Starting the machine 2-20
3.3 Warming up the machine 2-22
3.4 Conveyor unit setup flow 2-23
4. Preparing the component supply unit 2-25
4.1 Tape feeders 2-25
4.1.1 Setting the tape 2-25
4.1.2 Setting a tape feed pitch 2-30
4.1.3 Installation on the machine 2-34
4.2 Wafer tray changer 2-35
4.2.1 Setting a dicing frame (components) in the tray. 2-35
4.2.2 Setting the components in the magazine 2-36
4.2.3 Exchanging the magazine and supplying components 2-37
4.2.4 Teaching the wafer component positions 2-39
4.2.5 Exchanging the expander unit and pallet clamp 2-45
5. Settings on the machine side 2-48
5.1 Setting the "Package" parameter. 2-48
2
Chapter 3 Starting and ending production
1. Starting production 3-1
1.1 Resuming operation from the stopped point 3-6
1.1.1 Loading the saved data 3-7
1.1.2 Editing mount flags 3-7
1.2 Using the "block skip function" 3-8
1.2.1 Selecting the blocks 3-9
1.2.2 Starting operation 3-10
2. Ending production and turning power off 3-11
3
3.1 Production 3-13
5
7
9
3.5 Alignment 3-21
About this manual
The instruction manual of this machine is written for those who operate
this machine.
Please read this manual carefully for correct operations and pay
special attention to safety precautions.
After reading through this manual, please use this manual as an
occasional reference and keep it within reach.
About this manual
Contents
1. Using this manual i
1.1 Available manuals i
1.2 Manual contents ii
2. Contents of each chapter iii
3. Page layout iv