00195813-07_IM_SSW_605.03_SP3_DE EN.pdf - 第26页
Installat ion Manual, Station Software Version 605.03 SP 3 12 /2012 E dition 26 of 46 NOTICE → Touch t he calibratio n icon with in 20 secon ds, other wise calibrat ion is autom aticall y canceled. → Make s ure that you …
Installation Manual, Station Software Version 605.03 SP3 12/2012 Edition
25 of 46
Fig. 5-6: TouchWare Properties – Multiple Monitors tab (example for Monitor 2)
→ Click the number of the monitor you wish to calibrate.
→ Open the Calibrate tab.
Fig. 5-7: TouchWare Properties – Calibrate tab (example for Monitor 1)
→ Click the Calibrate button. An icon representing the calibration is shown on screen. An icon
representing a hand guides you through the calibration steps by pointing to the calibration icon you
must touch.
Fig. 5-8: Calibration marks
Installation Manual, Station Software Version 605.03 SP3 12/2012 Edition
26 of 46
NOTICE
→ Touch the calibration icon within 20 seconds, otherwise calibration is automatically
canceled.
→ Make sure that you are standing directly in front of the monitor.
→ Carry out calibration in the position (standing or seated) you normally adopt when
working at this screen.
→ Touch the calibration icon firmly and accurately with your fingertip.
→ Make sure that you do not inadvertently touch the screen with any other finger.
→ Touch the calibration icon with your finger and make sure that the yellow area is completely covered
by your finger. The message "Hold" appears around the hand icon.
→ Keep your finger on the calibration icon until the "Touch Enabled" message appears. A second
calibration icon now appears.
→ Repeat the steps described above for the second calibration icon.
A dialog box then appears asking you to test the calibration. You can carry out the calibration again if
you are not sure that you have carried it out correctly the first time.
→ Carry out the procedure described above for the second screen as well.
→ Click the Close button to close the program.
Installation Manual, Station Software Version 605.03 SP3 12/2012 Edition
27 of 46
5.3.3.2 Calibrating the Touch Screen for the D-Series
→ Select Start Program Files PenMount Utilities PenMount Control Panel to start the touch
screen calibration applet.
Fig. 5-9: PenMount Control Panel
→ Open the Multiple Monitors tab.
Fig. 5-10: PenMount Control Panel – Multiple Monitors tab
→ Check the Multiple Monitor Support box.
→ Click the Map Touch Screens button.
The "Mapping" dialog box opens.