Infinity Generic Tooling.pdf - 第18页

INFINITY MACHI NE PROG RAMMI NG STAGE 6 C - DE DICAT ED TOO LING 1.44 User Manual 15. If re quired, sl ide addition al magnetic pins beneath the plate assembly t o fully support it when printing wide boar ds. 16. Select …

100%1 / 52
INFINITY
MACHINE PROGRAMMING
STAGE 6C - DEDICATED TOOLING
User Manual 1.43
11. Fit the head prop.
12. Press Confirm (F1).
13. Fit the tooling tower to the manual tooling plate. Ensure the dowels on the
front edge of the tooling tower base are correctly seated in the holes in the
front edge of the manual tooling plate.
14. Verify the plate assembly orientation and fit the assembly to the tooling
tower. Ensure the dowels of the plate assembly are correctly seated in the
holes in the tooling tower.
Confirm
Lower
Head
INFINITY
MACHINE PROGRAMMING
STAGE 6C - DEDICATED TOOLING
1.44 User Manual
15. If required, slide additional magnetic pins beneath the plate assembly to fully
support it when printing wide boards.
16. Select Lower Head (F2).
The following window and menu bar is displayed:
17. Remove the head prop.
18. Select Confirm (F1).
19. Lower the printhead using two button control.
Adjust
Lower
Head
Board
Clamps
Set
Stop
Hazardous Operation
The head is about to be lowered
Remove the Head Prop and confirm that
everyone is standing clear.
Confirm Cancel
Confirm Cancel
INFINITY
MACHINE PROGRAMMING
STAGE 6C - DEDICATED TOOLING
User Manual 1.45
20. Close the front printhead cover.
21. Press the System button.
22. Select Board Width (F5). The message ‘Checking for a board on the
belts’ is displayed. Whilst the rear rail is moving the following message ‘Rail
Moving...’ is displayed.
23. Select Generic Tooling (F7).
The following window and menu bar is displayed:
NOTE
If contaminated squeegees are fitted, these should be replaced at this point.
24. Select Continue (F1). The print carriage travels to the rear of the machine
and the following message is displayed ‘Table at Home Height’.
25. Select Transprt Height (F3). The message ‘Table at Transport Height’ is
displayed.
26. Place a board on the input sensor of the upline conveyor of the machine.
27. Select Load (F1).
28. Select Auto Board (F1).
Adjust
Raise
Head
Remove
Cleaner
Board
Stop
Board
Width
Load
Width
Generic
Toolin g
Exit
Adjust
Raise
Head
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Generic
Tooling
Exit
Generic Tooling Warning
WARNING Paste may drip into the machine
Remove Squeegees NOW
Continue
Open
Cover
Exit
Continue
Open
Cover
Exit
Load
Transprt
Height
Board
Clamps
Change
Screen
Raise
Head
Exit
Load
Vision
Height
Home
Height
Board
Clamps
Change
Screen
Raise
Head
Exit
Auto
Board
Manual
Board