Infinity Generic Tooling.pdf - 第32页

INFINITY MACHI NE PROG RAMMI NG STAGE 6E - FORM FLEX TOOLING 1.58 User Manual 13. Select Au to Boa rd (F1) . 14. Select Raise Head (F7). 15. Raise the head using two button cont rol. The following windo w and menu bar ar…

100%1 / 52
INFINITY
MACHINE PROGRAMMING
STAGE 6E - FORMFLEX TOOLING
User Manual 1.57
keyboard, to change the parameter value.
6. Select Save (F2). The message ‘Saving fiducial data - Please wait Board
data file saved’ is displayed.
7. Select Exit (F8).
8. Select Generic Tooling (F7).
The following window and menu bar are displayed:
NOTE
If contaminated squeegees are fitted, these should be replaced at this point.
9. Select Continue (F1). The print carriage travels to the rear of the machine-
and the following message is displayed ‘Table at Home Height’.
10. Select Transprt Height (F3), the message ‘Table at Transport Height’ is
displayed.
11. Place a board at the input sensor of the upline conveyor.
12. Select Load (F1).
Save Next Previous Incr. Decr. Exit
Save Next Previous Incr. Decr. Exit
Save Next Previous Incr. Decr. Exit
Adjust
Raise
Head
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Generic
Tooling
Exit
Generic Tooling Warning
WARNING Paste may drip into the machine
Remove Squeegees NOW
Continue
Open
Cover
No
Continue
Open
Cover
No
Load
Transprt
Height
Board
Clamps
Change
Screen
Raise
Head
Exit
Load
Vision
Height
Home
Height
Board
Clamps
Change
Screen
Raise
Head
Exit
INFINITY
MACHINE PROGRAMMING
STAGE 6E - FORMFLEX TOOLING
1.58 User Manual
13. Select Auto Board (F1).
14. Select Raise Head (F7).
15. Raise the head using two button control.
The following window and menu bar are displayed:
16. Fit the head prop.
17. Press Confirm (F1).
18. Using the board on the rails as a template slide the appropriate size and
Auto
Board
Manual
Board
Exit
Unload
Vision
Height
Home
Height
Board
Clamp
Change
Screen
Raise
Head
Exit
Hazardous Operation
The head must be propped while it is
raised
Insert the Head Prop.
Confirm
Lower
Head
Confirm
Lower
Head
INFINITY
MACHINE PROGRAMMING
STAGE 6E - FORMFLEX TOOLING
User Manual 1.59
number of FormFlex blanking plates on to the tooling modules outside the
area of the squeegees/ProFlow transfer head. Secure the plates using the
thumbscrews.
19. Select Lower Head (F2).
The following window and menu bar is displayed:
Lower
Head
Hazardous Operation
The head is about to be lowered
Remove the Head Prop and confirm that
everyone is standing clear.
Confirm Cancel