Infinity Generic Tooling.pdf - 第52页

INFINITY MACHI NE PROG RAMMI NG STAGE 6F - AU TOFLEX TOOL ING 1.78 User Manual 39. Select Au to Boa rd (F1) . 40. Remove the b oard from the rai ls. 41. Select Continue (F1). 42. Go to S tage 7. Aut o Boar d Manu al Boar…

100%1 / 52
INFINITY
MACHINE PROGRAMMING
STAGE 6F - AUTOFLEX TOOLING
1.76 User Manual
and the following message is displayed ‘Table at Home Height’.
19. Select Transprt Height (F3). The message ‘Table at Transport Height’ is
displayed.
20. Place a board on the input sensor of the upline conveyor of the machine.
21. Select Load (F1).
22. Select Auto Board (F1).
23. Select Vision Height (F3). The message ‘Table at Vision Height. Check
Tooling Clearance’ is displayed.
24. Select Contact Height (F3).
The following window and menu bar is displayed:
25. Select Continue (F1). The message ‘Table at Contact Height. Check
Tooling Clearance’ is displayed.
Continue
Open
Cover
Exit
Load
Transprt
Height
Board
Clamps
Change
Screen
Raise
Head
Exit
Load
Vision
Height
Home
Height
Board
Clamps
Change
Screen
Raise
Head
Exit
Auto
Board
Manual
Board
Exit
Unload
Vision
Height
Home
Height
Board
Clamps
Change
Screen
Raise
Head
Exit
Contact
Height
Trans pr t
Height
Change
Screen
Raise
Head
Exit
Contact Height Warning
WARNING Check for obstructions between
the Rails and the Screen
Continue
Open
Cover
Exit
Continue
Open
Cover
Exit
INFINITY
MACHINE PROGRAMMING
STAGE 6F - AUTOFLEX TOOLING
User Manual 1.77
26. Select Raise Head (F7).
27. Raise the printhead using two button control.
28. Fit the head prop.
29. Press Confirm (F1).
30. Check that the setup of the tooling is adequate for the board, adjust as
necessary.
31. Select Lower Head (F2).
32. Remove the head prop.
33. Select Confirm (F1).
34. Lower the printhead using two button control.
35. Close the front printhead cover.
36. Press the System button.
37. Select Exit (F8).
The following window and menu bar is displayed:
38. Select Continue (F1).
Vision
Height
Raise
Head
Exit
Confirm
Lower
Head
Lower
Head
Confirm Cancel
Vision
Height
Raise
Head
Exit
Leaving Generic Tooling
WARNING You are about to return
to the Setup Page
Clear all tooling setup
equipment before proceeding
Continue Cancel
Continue Cancel
INFINITY
MACHINE PROGRAMMING
STAGE 6F - AUTOFLEX TOOLING
1.78 User Manual
39. Select Auto Board (F1).
40. Remove the board from the rails.
41. Select Continue (F1).
42. Go to Stage 7.
Auto
Board
Manual
Board
Continue Head