NR_Mechanischer_Stopper.pdf - 第140页
Assembly Instructions PCB Stopper Sin gle Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series Edition 06/2007 140 12.6.3 Connection of pneumatic lines O Connect the two air lines of the rotating cylinde r to the t…
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
139
12.6.2 Preparing and terminating pneumatic hoses (S-27HM)
O Configure the pneumatic hoses as shown in the following figure.
Fig. 116 Overview of pneumatic hoses (S-27HM)
Note for single conveyor
With a single conveyor only one PUN 3 hose is required. The unneeded connection is closed
with a blind plug.
4-fold distributor PUN 6 to 4 x PUN 4
with PUN 4 hose to compressed air
supply and PUN 6 plug
200 mm PUN 4 hose to compressed
air supply, width
adjustment
2 x 200 mm PUN 3hose with Y-distrib-
utor to 2 x 100 mm PUN 3 hose to the
solenoid valve PA2
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
140
12.6.3 Connection of pneumatic lines
O Connect the two air lines of the rotating cylinder to the two solenoid valves of the pneumatic
valve unit.
The blue line is linked to connection 4, the black line to connection 2.
Fig. 117 Connection of pneumatic lines
Connection 4 Connection 2
Black = Connec-
tion to rotating
cylinder
Insert stopper
with adjustable
throttle
Blue = Connec-
tion to rotating
cylinder
Withdraw stop-
per with adjust-
able throttle
Compressed air
supply
Solenoid valve
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
141
12.7 Safety instructions
CAUTION
The safety instructions in the Operating Safety section of the User Manual and Service Manual
have priority. 12
The SIPLACE placement machines are powered by mains voltage.
Parts of the system therefore conduct dangerous electricity inside the machine even while the
main switch is turned off.
Inappropriate handling of the machines or touching live parts in the machine can cause death or
serious injury and can also result in considerable damage to property.
Before all work, carry out a proper shut-down of the operating system then turn off the machine
at the main switch and isolate it from the mains. In addition, the compressed air supply must be
turned off at the main valve of the compressed air unit in the machine base and the compressed
air lines must be bled by actuating the needle valve on the compressed air unit.
Danger: For anyone wearing a heart pacemaker it is not permitted to work near linear motors, as
described in detail in the User Manual and the Service Manual, Chapter "Special Safety Instruc-
tions when working in vicinity of powerful magnetic fields" .
Obey the applicable accident prevention regulations, DIN standards and special safety codes of
your country at all times.
Observe the information on residual voltage in the Section "Operating Safety".
Observe the ESD regulations as described in the User Manual, Section "Operating Safety".
During retrofitting secure the machine carefully against use by other persons and against unau-
thorized power-up, as described in the User Manual in the Section "Locking the machine....".
There is additional, higher risk of accident when working with the SITEST program. The SITEST
program may only be started by persons trained and authorized to do so.
12