NR_Mechanischer_Stopper.pdf - 第142页
Assembly Instructions PCB Stopper Sin gle Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series Edition 06/2007 142
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
141
12.7 Safety instructions
CAUTION
The safety instructions in the Operating Safety section of the User Manual and Service Manual
have priority. 12
The SIPLACE placement machines are powered by mains voltage.
Parts of the system therefore conduct dangerous electricity inside the machine even while the
main switch is turned off.
Inappropriate handling of the machines or touching live parts in the machine can cause death or
serious injury and can also result in considerable damage to property.
Before all work, carry out a proper shut-down of the operating system then turn off the machine
at the main switch and isolate it from the mains. In addition, the compressed air supply must be
turned off at the main valve of the compressed air unit in the machine base and the compressed
air lines must be bled by actuating the needle valve on the compressed air unit.
Danger: For anyone wearing a heart pacemaker it is not permitted to work near linear motors, as
described in detail in the User Manual and the Service Manual, Chapter "Special Safety Instruc-
tions when working in vicinity of powerful magnetic fields" .
Obey the applicable accident prevention regulations, DIN standards and special safety codes of
your country at all times.
Observe the information on residual voltage in the Section "Operating Safety".
Observe the ESD regulations as described in the User Manual, Section "Operating Safety".
During retrofitting secure the machine carefully against use by other persons and against unau-
thorized power-up, as described in the User Manual in the Section "Locking the machine....".
There is additional, higher risk of accident when working with the SITEST program. The SITEST
program may only be started by persons trained and authorized to do so.
12
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
142
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
143
13 Retrofitting SIPLACE HS-60 / D4
13.1 Preparatory work
Caution: Before the stopper is mounted in the machine, it should be adjusted with the guide strip
and the shims. Care should be taken to ensure that the stopper is not too loose or too tight. The
graduation of the shims is 0.1mm.
(See also Fig. 209, page - 232.) 13
13
O Change over to the SITEST.
O Select "Conveyor" and "Conveyor width".
O For a single conveyor, set the conveyor width to maximum.
O For a dual conveyor set the conveyor width as follows:
O Shut down the operating system and switch off the placement machine at the main switch.
O Remove the plates of the lifting table and the cover over the conversion board for the PCB con-
veyor.
O Remove the cover of conversion board.
O Remove the metal cover of the cable ducts.
O Remove the cable duct covers.
In placement area 2 the lifting table needs to be moved back 20 mm.
So start the rest of the conversion in placement area 2.
O On dual conveyor machines, remove the following nozzle changers:
– Conveyor left: Nozzle changer at location 2
– Conveyor right: Nozzle changer at location 3
Fixed conveyor left Conveyor track 1: 50 mm Conveyor track 2: 200 mm
Fixed conveyor right Conveyor track 1: Max. width Conveyor track 2: 50 mm