4OM-1054-002.pdf - 第56页
(24) Head Up/Down Section 1.3 Maintenance Spots 0307-005 1-42 AGS01ETRP Fig. 4A48 Oil Inlets Every 3 Months Lubrication (DAPHNE EPONEX GREASE No. 1) Apply grease with a dispense gun. * Use No. 14 (olive) nozzle. Cam Foll…
(23) Nozzle Guide Section
1.3 Maintenance Spots
0211-004 1-41 AGS01ETRP
Fig. 4A47
(24) Head Up/Down Section
1.3 Maintenance Spots
0307-005 1-42 AGS01ETRP
Fig. 4A48
Oil Inlets
Every 3 Months Lubrication (DAPHNE EPONEX GREASE No. 1)
Apply grease with a dispense gun.
* Use No. 14 (olive) nozzle.
Cam Follower of Top Block 3M26
Upper Section of Linear Guide 3M27
Every 3 Months Lubrication (DAPHNE EPONEX GREASE No. 3)
Follow the steps below for the lubrication.
1. Close the air valve and allow the air to bleed out of the machine.
2. Rotate the rotary turret with the hand-rotating wheel to move the linear
guide to be lubricated between Stations #3 and #4
(Turret Angle: 108 degrees).
3. Set the dispense gun to "1".
4. Insert the nozzle to be used into the oil inlet and inject grease slowly,
spending about 10 seconds.
Note: Inject grease only once.
* Use the HL2-type nozzle.
Grease should be applied every 3 months after the initial month.
1.3 Maintenance Spots
0307-005 1-43 AGS01ETRP
Fig. 4A49
Lower Section of Linear Guide 3M28
Every 3 Months Lubrication (DAPHNE EPONEX GREASE No. 3)
Follow the steps below for the lubrication.
1. Close the air valve and allow the air to bleed out of the machine.
2. Rotate the rotary turret with the hand-rotating wheel to move the
linear guide to be lubricated between Stations #5 and #6
(Turret Angle: 108 degrees).
3. Set the dispense gun to "1".
4. Insert the nozzle to be used into the oil inlet and inject grease slowly,
spending about 10 seconds.
Note: Inject grease only once.
* Use the HL2-type nozzle.
Grease should be applied every 3 months after the initial month.
Oil Inlets