4OM-1054-002.pdf - 第87页
021 1-004 1-71 AGS01ETRP 1.4 Maintenance Method (1 1) Unlock the [EMERGENCY STOP] switch and press the [RESET] button. Press the [POWER ON] button to power the machine. Press the [ALL] button (entitled "ZERO").…
0211-004 1-70 AGS01ETRP
1.4 Maintenance Method
(8) Unlock the [EMERGENCY STOP] switch and press the [RESET]
button.
Press the [POWER ON] button to power the machine.
Press the [ALL] button (entitled "ZERO"). In two seconds, press the
[ENABLE] button on the operation panel.
(9) Press the [Next] button.
(10) Press the [F1] and [F2] buttons (entitled "FEEDER READY").
When the [ENABLE] button on the operation panel is pressed in
two seconds after the [ON] button (entitled "MOVE"), the following
sheet appears.
Press the [EMERGENCY STOP] switch and open the F2 and cen-
tral doors.
Apply grease to the nipple on the slide block of a linear guide.
After that, close the F2 and central doors.
Fig. 4A84-6
0211-004 1-71 AGS01ETRP
1.4 Maintenance Method
(11) Unlock the [EMERGENCY STOP] switch and press the [RESET]
button.
Press the [POWER ON] button to power the machine.
Press the [ALL] button (entitled "ZERO"). In two seconds, press
the [ENABLE] button on the operation panel.
(12) Press the [Next] button. The following sheet appears.
Fig. 4A84-7
Press the [F1] and [F2] buttons (entitled "FEEDER READY").
When the [ENABLE] button on the operation panel is pressed in
two seconds after the [ON] button (entitled "MOVE"), the aging op-
eration of the feeder carriage section starts.
0211-004 1-72 AGS01ETRP
1.4 Maintenance Method
(13) After the aging is completed, the following tab sheet appears.
Fig. 4A84-8
(14) When the [ENABLE] button on the operation panel is pressed in
two seconds after the [ON] button (entitled "MOVE"), the following
sheet appears.
Fig. 4A84-9