4OM-1054-002.pdf - 第58页

(25) Control Box Section 1.3 Maintenance Spots 021 1-004 1-44 AGS01ETRP Fig. 4A50

1.3 Maintenance Spots

0307-005 1-43 AGS01ETRP

Fig. 4A49

Lower Section of Linear Guide 3M28

Every 3 Months Lubrication (DAPHNE EPONEX GREASE No. 3)

Follow the steps below for the lubrication.

1. Close the air valve and allow the air to bleed out of the machine.

2. Rotate the rotary turret with the hand-rotating wheel to move the

linear guide to be lubricated between Stations #5 and #6

(Turret Angle: 108 degrees).

3. Set the dispense gun to "1".

4. Insert the nozzle to be used into the oil inlet and inject grease slowly,

spending about 10 seconds.

Note: Inject grease only once.

* Use the HL2-type nozzle.

Grease should be applied every 3 months after the initial month.

Oil Inlets

(25) Control Box Section

1.3 Maintenance Spots

0211-004 1-44 AGS01ETRP

Fig. 4A50

(26) Filters and Cooling Fans in Each Section

1.3 Maintenance Spots

0211-004 1-45 AGS01ETRP

Fans on Top of Machine 3M30

Every 3 Months Cleaning

Remove the filters from the cooling fans on the top

of the main body and clean them with a vacuum

cleaner.

After cleaning, put the filters back in place.

Filter of Main Machine Driving Section 3M31

Every 3 Months Cleaning

Clean the filter with a vacuum cleaner.

Cooling Fans of Feeder Carriage Sections 3M33

Every 3 Months Cleaning

Remove the filters of the cooling fans and clean

them with a vacuum cleaner.

After cleaning, put the filters back in place.

Filter of Oil Cooler 3M32

Every 3 Months Cleaning

Detach the filter and clean it with a vacuum cleaner.

After cleaning, put the filter back in place.

555

Fig. 4A55

Fig. 4A56

Fig. 4A57 Top View of Machine