DFD6361-Maintenance.pdf - 第443页
E-7 Procedures for calling up the NCS SENSOR C LEANING screen [screen 4.8] (Continued) Step No. Do This 4 Press the <F8 > button to cal l up the NCS SENS OR CLEANING screen [scr een 4.8]. - The protection cover for…
E-6
1-1-1. Calling up the NCS SENSOR CLEANING screen
[screen 4.8]
Procedures for calling up the NCS SENSOR CLEANING screen [screen 4.8]
Step No. Do This
1
Stop the spindle rotation.
2
Turn OFF the wheel coolant water supply.
3
Press the <F4> button on the MAIN MENU screen [screen 0.0]
to call up BLADE MAINTENANCE screen [screen 4.0].
E-7
Procedures for calling up the NCS SENSOR CLEANING screen [screen 4.8] (Continued)
Step No. Do This
4
Press the <F8> button to call up the NCS SENSOR CLEANING
screen [screen 4.8].
- The protection cover for the non-contact setup block opens.
- The X-axis automatically moves to its origin position.
5
Press the <F1> button to turn OFF the sensor protecting water
from the non-contact setup block, if it is ON.
6
Press the <F2> button to turn OFF the air blow from the non-
contact setup block, if it is ON.
Continued in the next section.
E-8
1-1-2. Cleaning of the non-contact setup sensor
Position of the non-contact setup sensor
The illustration below shows the location of the non-contact setup sensor.
Z1-axis Z2-axis
Non-contact setup sensor
Procedures for cleaning the non-contact setup sensor
WARNING
If your fingers or hands are placed under the rotating spindle, they
may be caught or cut off.
Before opening the splash cover, visually make sure from the outside
of the splash cover that the spindle stops completely. Also, do not
position your fingers or hands under the rotating spindle.