00198152-02_OM_VirtualInkspotHandling_for_SSW7xx_EN.pdf - 第5页
Virtual Inkspot Handling for SSW 7xx / Operating Manual 10/2017 Edition 5 1 Introduction This document des cribes the SIPLACE Virtual Inkspot Handling opt ion ( VIH ) and how to configure it for stat ion software 7xx . I…
Virtual Inkspot Handling for SSW 7xx / Operating Manual 10/2017 Edition
5
1 Introduction
This document describes the SIPLACE Virtual Inkspot Handling option (VIH) and how to
configure it for station software 7xx. It also contains information on the scope of delivery and
requirements for successful operation.
1.1 Scope of Delivery
Please contact the sales representative to obtain an offer for this service!
1.1.1 Packages
● SIPLACE Line Operations Software Package, item no. [00116525-xx] containing:
– Whispering Down the Line for Barcode
● This Operating Manual, item no. [00198152-xx]
1.1.2 Languages
The software is available in English and German. The documentation is available in English.
Virtual Inkspot Handling for SSW 7xx / Operating Manual 10/2017 Edition
6
2 Functionality
With the Virtual Inkspot Handling option (in the following referred to as VIH), external systems
can define which panels of a board are to be produced and which ones shall be skipped. A panel is
a defined portion of a board. Compared to the physical inkspot concept, this concept is more
flexible.
– It can be included into the ongoing production process as external systems may decide for
each panel individually, if it is in a good or bad state and further process steps should be
omitted. Typically, an external system has already measured a board and has the information
which panels are good and which are bad. Using this information via VIH has the advantage
that no physical inkspots have to be read by the PCB camera. This enhances the performance
especially for boards with a large number of panels.
– It can be used if panels have no space for a physical inkspot.
This chapter gives an overview of the VIH history and functionality.
2.1 WDTL from Station Software 704.1
From station software version 704.1, the WDTL function was improved as follows:
– No configuration is required at the station. Configuration is performed via the line (SMEMA
cluster) and the inkspot handling is enabled in the setup.
– Additionally, inkspot files can be used for defining inkspots. All settings are made locally in XML
files and configured at the first station in the line.
– Information on inkspots is read by the barcode reader on the 1
st
placement machine and is
transmitted to the next placement machines in the line.
– WDTL is based on the identification of boards with the board transport sensors.
– No barcode readers required on the succeeding placement machines.
Requirements:
– One Whispering down the line license per station is required to use WDTL of inkspots.
– The feature only works in pure 704 SW lines, whispering to a station with another station
software version, e.g. 605 is not possible.
– If another device e.g. AOI is present between the placement machines, whispering is only
possible if the placement machine after the AOI is equipped with a barcode reader and is
defined as a line (SMEMA cluster) in SIPLACE Pro. If not, the inkspots will be read again in the
placement machine after the AOI.