00194591-01.pdf - 第40页
3 In stal latio n Installation Guide SIPLACE Setup Center 3.2 Installation of SIPLACE Setup Center and Possible Setu p Types Edition 03/2005 EN 40 3.2.3.9 Bind or J oin the scanner t o a RF st ation Y o u can connec t m …
Installation Guide SIPLACE Setup Center 3 Installation
Edition 03/2005 EN 3.2 Installation of SIPLACE Setup Center and Possible Setup Types
39
Aiming pointer (standard is 300 ms). The aiming pointer holds the laser beam on a single spot
before reading a barcode.
3
3
3
The scanner is now ready configured. Now it needs to be bound to a RF station as described
below.
3
300ms
500ms
1sec
Aiming system disabled
3 Installation Installation Guide SIPLACE Setup Center
3.2 Installation of SIPLACE Setup Center and Possible Setup Types Edition 03/2005 EN
40
3.2.3.9 Bind or Join the scanner to a RF station
Youcan connectmorethanone scanner to one RFstation.With the first scanner youneedtoscan
the barcode label
Bind, with all further scanners you need to scan the barcode label Join. 3
Please follow one of the following instructions according to your choice. 3
3
Note
You can never recognize if the Dragon scanner has the configuration Bind or Join.Therefore
please note your configuration you did. If you do not remember your configuration you have to
configure it once again. 3
Bind
→Make sure the RF station is on (yellow
light is on).
→When scanning the following barcode
thegreenLEDofthescannerisactivefor
about 10 seconds. Put the scanner into
the RF station during these 10 seconds.
Join
→The following barcode may be used to
add further scanners to one RF station.
→Keep in mind that the first scanner need
tobeboundtothestationasdescribed
on the left side. Each scanner must be
set to a unique address (see “Setting of
the Scanner Address” on page 38).
The connection can be tested by scanning
anybarcodewiththescanner.Afterthescan-
ning, the yellow LED ”power/data” is
switched off for 0.5 seconds.
Bind
Join
Installation Guide SIPLACE Setup Center 3 Installation
Edition 03/2005 EN 3.2 Installation of SIPLACE Setup Center and Possible Setup Types
41
3.2.3.10 RF Station Communication Configuration
The following barcodes are required to set up the RF station and activates the RF station serial
communication to the PC.
3
Note
The following barcodes are required to set up the RF station and activates the RF station serial
communication to the PC. The configuration of the RF station communication shall be performed
once. Also if the barcode reader is reconfigured. 3
3
3
3.2.4 Testing the Setup
→Connect the RF station to the Setup Center PC to the COM interface.
→Make sure, the RF station is on (yellow LED is active).
→If Setup Center is already running open the configuration dialog, otherwise start Setup Center.
→Select the COM port in the configuration dialog of SIPLACE Setup Center and apply settings.
→Press successively all three buttons on the scanner.
→Now the main menu text SIPLACE Setup Center is displayed on the scanner.
3
Restore OM-DRAGON™ default
RS232