00198281-02_JG SmartFeeder 24-104 mm X_EN.pdf - 第12页
Operating the Feeder Module - Preparing the Tape Material 12 www.asm-smt.com 1.8 Preparing the Tape Material Prepare the tape with enough (approx. 35 cm) protruding cover foil. 1. Insert the tape reel into the tape con- …
Operating the Feeder Module - Feeder Log Off and Removal
11
www.asm-smt.com
1.7 Feeder Log Off and Removal
1. Press the back of the removal handle.
This handle will protrude and trigger the
log off procedure.
Once the status displays have gone off,
remove the feeder module from the
changeover table.
2. Use the removal handle to pull the feeder
module a little bit out of the component
table.
3. Use the handle to pull the feeder module
completely out of the component table.
Operating the Feeder Module - Preparing the Tape Material
12
www.asm-smt.com
1.8 Preparing the Tape Material
Prepare the tape with enough (approx. 35 cm)
protruding cover foil.
1. Insert the tape reel into the tape con-
tainer. Use a spindle, if required.
2. Remove as much of the protruding foil as
needed to leave only a few empty tape
pockets.
3. Cut the end of the empty tape.
4. Fold the protruding cover foil over down-
wards.
Operating the Feeder Module - Inserting the Tape
13
www.asm-smt.com
1.9 Inserting the Tape
1. Push the prepared end of the tape into the
tape duct.
2. The tape will reappear at the top opening of
the tape duct.
3. Press the "pickup window actuator" to raise
the pickup window.
Then push the tape further to the center
under the pickup window.
4. Pull the cover foil up and out of the pickup
window and pull it backwards.