00198281-02_JG SmartFeeder 24-104 mm X_EN.pdf - 第26页

Splicing - Required Tools and Materials 26 www.asm-smt.com Alternatively, you could also use the multi- frame tape splice gripper shown in the dia- gram. 1. Multi-frame tape splice gripper 2. Splicing rivet strips 3. Adh…

Splicing - Required Tools and Materials

www.asm-smt.com

2 Splicing2.1 Required Tools and Materials

These tools and materials are required for tape

splicing:

1. Adhesive tape (small)

2. Tweezers

3. Scissors

4. Splicing rivets

5. Splicing tool

6. Adhesive tape (large)

Splicing - Required Tools and Materials

www.asm-smt.com

Alternatively, you could also use the multi-

frame tape splice gripper shown in the dia-

gram.

1. Multi-frame tape splice gripper

2. Splicing rivet strips

3. Adhesive tape strips, red

4. Adhesive tape strips, yellow

5. Adhesive tape strips

Splicing - Preparing the Old End Tape

www.asm-smt.com

2.2 Preparing the Old End Tape

Old end tape:

1. The tape end protrudes from the feeder

module.

2. Cut carrier tape exactly between two

pockets in the middle of the hole, as

shown in picture. All pockets must be full

to the end of the tape.

Note:

The tape splice must have enough of the old

tape, so that the machine does not need to be

stopped.