00198281-02_JG SmartFeeder 24-104 mm X_EN.pdf - 第27页

Splicing - Preparing the Old End Tape 27 www.asm-smt.com 2.2 Preparing the Old End Tape Old end tape: 1. The tape end protrudes from the feeder module. 2. Cut carrier tape exactly between two pockets in the middle of the…

Splicing - Required Tools and Materials

www.asm-smt.com

Alternatively, you could also use the multi-

frame tape splice gripper shown in the dia-

gram.

1. Multi-frame tape splice gripper

2. Splicing rivet strips

3. Adhesive tape strips, red

4. Adhesive tape strips, yellow

5. Adhesive tape strips

Splicing - Preparing the Old End Tape

www.asm-smt.com

2.2 Preparing the Old End Tape

Old end tape:

1. The tape end protrudes from the feeder

module.

2. Cut carrier tape exactly between two

pockets in the middle of the hole, as

shown in picture. All pockets must be full

to the end of the tape.

Note:

The tape splice must have enough of the old

tape, so that the machine does not need to be

stopped.

Splicing - Preparing the New Tape

www.asm-smt.com

2.3 Preparing the New Tape

1. Peel off the foil (about the width of a com-

ponent pocket) towards the back.

2. Cut the tape exactly between two pockets

in the middle of the perforation, as shown

in picture. All pockets must be full to the

end of the tape.

Note:

Make sure that you do not cut the foil, so that

the new and old foils overlap.