00198281-02_JG SmartFeeder 24-104 mm X_EN.pdf - 第13页
Operating the Feeder Module - Inserting the Tape 13 www.asm-smt.com 1.9 Inserting the Tape 1. Push the prepared end of the tape into the tape duct. 2. The tape will reappear at the top opening of the tape duct. 3. Press …
Operating the Feeder Module - Preparing the Tape Material
12
www.asm-smt.com
1.8 Preparing the Tape Material
Prepare the tape with enough (approx. 35 cm)
protruding cover foil.
1. Insert the tape reel into the tape con-
tainer. Use a spindle, if required.
2. Remove as much of the protruding foil as
needed to leave only a few empty tape
pockets.
3. Cut the end of the empty tape.
4. Fold the protruding cover foil over down-
wards.
Operating the Feeder Module - Inserting the Tape
13
www.asm-smt.com
1.9 Inserting the Tape
1. Push the prepared end of the tape into the
tape duct.
2. The tape will reappear at the top opening of
the tape duct.
3. Press the "pickup window actuator" to raise
the pickup window.
Then push the tape further to the center
under the pickup window.
4. Pull the cover foil up and out of the pickup
window and pull it backwards.
Operating the Feeder Module - Inserting the Tape
14
www.asm-smt.com
1.10 Inserting the Tape
5. Bring the pickup window down again.
Make sure that one hole of the tape each is
correctly fixed by a pin of the pin wheel.
6. Thread the cover foil into the foil removal.
7. Press the yellow FOIL button. The foil
removal starts and the cover foil gets
pulled in.
Note:
Take care that the cover foil is exactly on the
foil rocker. The foil motor will be deactivated
when the cover foil is tight on the foil rocker.