00198281-02_JG SmartFeeder 24-104 mm X_EN.pdf - 第29页

Splicing - Splicing Narrow Tapes 29 www.asm-smt.com 2.4 Splicing Narrow Tapes 1. Place the rivet on the pins, on the prongs. 2. Place the end of the old tape over half of the rivet and then close the right-hand locking o…

Splicing - Preparing the New Tape

www.asm-smt.com

2.3 Preparing the New Tape

1. Peel off the foil (about the width of a com-

ponent pocket) towards the back.

2. Cut the tape exactly between two pockets

in the middle of the perforation, as shown

in picture. All pockets must be full to the

end of the tape.

Note:

Make sure that you do not cut the foil, so that

the new and old foils overlap.

Splicing - Splicing Narrow Tapes

www.asm-smt.com

2.4 Splicing Narrow Tapes

1. Place the rivet on the pins, on the prongs.

2. Place the end of the old tape over half of

the rivet and then close the right-hand

locking of the splicing tool, as shown in

the diagram.

3. Place the start of the new tape over the

other half of the rivet and then close the

other locking of the splicing tool. The foil

must protrude over the end of the old

tape, at the top.

4. Crimp the splicing tool, until it audibly

clicks.

Splicing - Splicing Narrow Tapes

www.asm-smt.com

1. Remove one half of the protector strip.

Attention:

Do not touch the sticky surface!

2. Lay the adhesive strip on top of the com-

ponent tape and press firmly

3. Remove carefully the second half of the

protector strip and press firmly on the ad-

hesive strip.

4. To finish splicing the tape, press the spli-

cing tool until this releases itself.

Open the locking of the splicing tool afterwards

and remove the tape.