4OM-1011-002.pdf - 第143页

0305-001 Tg0860-PM-MM 6.8.5 Nozzle Stocker Offset Notes: (a ) A special jig (option) is required for accurate teaching operations. Set the jig to the stocker address position to be taught in advance. (b) If the offset da…

0305-001 Tg0860-PM-MM3-91

6.8 UNIT MANUAL ALIGNMENT TEACH Display

*5 [TEACH START] Key

When this key is selected and the [MOVE] button is pressed, the P.E.C.

recognition camera moves to the feeder position specified in the “FEEDER

#” data box.

The pick-up point of the feeder appears on the recognition monitor. Perform

the manual alignment operation, using the track ball.

Refer to “6.8.9 Teaching Operation with Trackball” for details.

*6 OLD DATA

Displayed are the values (the parameters related to the indicated feeder #)

before the feeder (B) offset data is taught.

*7 NEW DATA

Displayed are the values (the parameters related to the indicated feeder #)

after the feeder (B) offset data is taught.

Before the teaching operation is performed, the same values as *6 are dis-

played.

0305-001 Tg0860-PM-MM

6.8.5 Nozzle Stocker Offset

Notes: (a) A special jig (option) is required for accurate teaching operations.

Set the jig to the stocker address position to be taught in advance.

(b) If the offset data is not taught accurately, the nozzle change opera-

tion cannot be performed correctly.

• Set the jig or a nozzle on the nozzle stocker and perform the offset teaching

operation for the feeder through manual alignment operation.

When the [NOZZLE STOCKER OFFSET] key is pressed at the “UNIT

MANUAL ALIGNMENT TEACH” display, the following display appears on

the screen.

[MASTER]

When this key is pressed, the display appears where the nozzle stoker entire

deviation is taught.

[LOCAL]

When this key is pressed, the display appears where the nozzle stokers 1 to

10 are taught individually.

3-92

6.8 UNIT MANUAL ALIGNMENT TEACH Display

Fig. 4C162

0305-001 Tg0860-PM-MM

3-93

When the [MASTER] key is pressed at the "NOZZLE STOCKER OFFSET" display

(Fig. 4C162), the display shown in Fig. 4C163 appears.

Note: When the [LOCAL] key is pressed, the same display appears.

6.8 UNIT MANUAL ALIGNMENT TEACH Display

Fig. 4C163

Fig. 4C164

[RTN] Key

[DON’T SAVE] Key[SAVE] Key

"NOZZLE STOCKER OFFSET" display (Fig. 4C162)