4OM-1011-002.pdf - 第28页

0305-001 Tg0860-PM-MM 1-13 Fig. 4A17 T eaching Plate Sec- tion T eaching Plate (Component Recognition Offset Jig) Checking and Cleaning • Check for any damage. • Clean it using air blow for the cam- era. Position of T ea…

0305-001 Tg0860-PM-MM

1-12

Table 4A7

6. Monthly Maintenance

Note: Grease Symbols

DE1 : DAPHNE EPONEX GREASE No.1

NM1 : NEW MOLYNOC GREASE No.1

6. Monthly Maintenance

Maintenance Spots Check

Name

Fig.

No.

Description Grease

Cleaning

Tools,

Nozzles, etc.

Teaching Plate

Section

Teaching Plate

(Component

Recognition Offset

Jig), Position of

Teaching Plate, Back

Light Stage

4A17 Checking and

Cleaning

− − − Air Blow for

Camera

Nozzle Stocker Cam Follower 4A18 Cleaning and

Lubrication

− − − Oiled Rag,

NM1, Brush

Nozzle Storage

Section

4A18 Cleaning − − − Rag

Inside of Vacuum

Nozzle

4A19 Cleaning − − − Air Gun

Hole of Vacuum

Nozzle

4A19 Cleaning − − − Air Gun

Vacuum Nozzle End 4A19 Cleaning − − − Rag

Placement Head Vacuum Filter 4A20 Checking − − − Vacuum

Filter,

Replacement

Jig

0305-001 Tg0860-PM-MM

1-13

Fig. 4A17 Teaching Plate Sec-

tion

Teaching Plate (Component

Recognition Offset Jig)

Checking and Cleaning

• Check for any damage.

• Clean it using air blow for the cam-

era.

Position of Teaching Plate

Checking and Cleaning

• Check for any damage.

• Clean it using air blow for the cam-

era.

Back Light Stage

Checking and Cleaning

• Check for any damage.

• Clean it using air blow for the cam-

era.

Beam A Side

Beam B Side

Note: Sebum nor oil, etc., should not adhere to the teaching plate (component rec-

ognition offset jig), the position of the teaching plate, and the back light stage.

If sebum or oil, etc., adheres, wipe it off with a lens cleaning cloth which

contains a small amount of alcohol.

6. Monthly Maintenance

0305-001 Tg0860-PM-MM

1-14

Fig. 4A19 Vacuum Nozzle

6. Monthly Maintenance

Inside of Vacuum Nozzle

Cleaning

Blow air to the inside of the vacuum

nozzle.

Hole of Vacuum Nozzle

Cleaning

Blow air to the hole of the vacuum

nozzle.

Vacuum Nozzle End

Cleaning

Clean it with a rag.

Fig. 4A18 Nozzle Stocker

Nozzle Storage Section

Cleaning

Remove dirt and dust using a rag.

Cam Follower

Cleaning and Lubrication (NM1)

(1) Wipe off old grease with an oiled

rag.

Note: Take care not to leave

any waste thread.

(2) Apply new grease with a brush,

etc.

Beam A Side

Beam B Side

Beam A Side

Beam B Side

Note: Sebum nor oil, etc., should not adhere to the surface of the diffusion plate.

Do not use a rag to wipe off dirt.

Refer to “1.7 Vacuum Nozzles of Section 2 in Volume 1” for details.

Diffusion

Plate

Note