00192471-03.pdf - 第129页
User Manual SIPLAC E HS-50 4 Component han dling Software Version SR.50x.xx 01/2006 US Edition 4.3 Setting up the feeder feeders 129 4 Fig. 4.3 - 1 Inserting 30 or 45 mm wide feeder modules on the component table (1) F e…
4 Component handling User Manual SIPLACE HS-50
4.3 Setting up the feeder feeders Software Version SR.50x.xx 01/2006 US Edition
128
4.3 Setting up the feeder feeders
4.3.1 Preparing the component table and feeder for set-up
Æ Select the setting range for the feeder module to be used.
Æ Move the placement head to the waiting position and press the emergency stop button.
Æ Open the protective covers.
Æ Clean the contact surface for the feeder modules and the contact surface for the feeder mod-
ules on the component table.
Æ Place the feeder module on the previously selected track on the component table (see Vibrator
configuration).
4.3.2 Insert the feeder
Æ Insert the feeder so that the back of the feeder is held by the centering ball and the front is fixed
in place by the corresponding centering pin on the component table. Make sure that the feeder
is placed on the component table in the correct position for its width.
Æ Check that the feeder is firmly seated on the component table.
Æ Connect the feeder plug to the socket beneath the location.
PLEASE NOTE 4
When you connect the feeder, make sure that you use the right socket for the location since
the feeder receives the control pulse via this socket. The feeder module may not work cor-
rectly if it is not connected to the right socket. 4
Æ Close the protective covers and switch the control on again.
Æ Carry out a refill check if necessary.
Æ Continue placement.
User Manual SIPLACE HS-50 4 Component handling
Software Version SR.50x.xx 01/2006 US Edition 4.3 Setting up the feeder feeders
129
4
Fig. 4.3 - 1 Inserting 30 or 45 mm wide feeder modules on the component table
(1) Feeder module, 30 mm wide
(2) Feeder module, 45 mm wide
(3) Feeder module, 30 mm wide
4 Component handling User Manual SIPLACE HS-50
4.4 Tape container Software Version SR.50x.xx 01/2006 US Edition
130
4.4 Tape container
4.4.1 Overview
Reels up to 15" in diameter may be used, although for 15" reels you should use spindles as well.
Insert the spindles into the partitions as shown in Fig. 4.4 - 1
. 4
PLEASE NOTE 4
We recommend that you use spindles if the tape reel diameter exceeds 5". This will ensure that
the feeder modules operate reliably.
Fig. 4.4 - 1 Component table and tape container
(1) Component table (2) Spindle position for 15" reels
(3) Waste tape container (4) Partition
(5) Tape container (6) Spindles