00192471-03.pdf - 第97页
User Manual SIPLAC E HS-50 3 What to do when ... Software Version SR.50x.xx 01/2006 US Edition 3.1 Switching on the SIPLACE line 97 3.1.3 Switching on the st ation / starting the user inter face of the station co mputer …
3 What to do when ... User Manual SIPLACE HS-50
3.1 Switching on the SIPLACE line Software Version SR.50x.xx 01/2006 US Edition
96
Æ Check to make sure that the stations are connected to power and to the compressed air supply.
Æ Carry out a visual inspection of the stations. In particular, make sure that there are no obstruc-
tions in the traveling range of the gantries.
Æ Make sure that the z-axes of all the heads are in the top end position.
Æ Close the feeder covers and the protective covers.
Æ Make sure that there is no diskette in the floppy drive of the station computer.
User Manual SIPLACE HS-50 3 What to do when ...
Software Version SR.50x.xx 01/2006 US Edition 3.1 Switching on the SIPLACE line
97
3.1.3 Switching on the station / starting the user interface of the station computer
program
ATTENTION
Switch on the station only after the desktop is displayed on the line computer monitor. Otherwise,
communication problems may occur. 3
Æ Switch on the station on the main switch and check to see if the manometer displays the re-
quired operating pressure after you have switched the station on.
The station computer software is uploaded. When the line computer is connected and commu-
nication is error-free, the Main view of the station computer user interface appears for the "Op-
erator" user class after approximately 2 minutes (see Fig. 3.1 - 1
).
3
Fig. 3.1 - 1 Main view after loading the station computer software
NOTE
The current state of the station is displayed in the status field in the "State" line, and the action you
are to execute is displayed in the "Action:" line (see Fig. 3.1 - 1). 3
3 What to do when ... User Manual SIPLACE HS-50
3.1 Switching on the SIPLACE line Software Version SR.50x.xx 01/2006 US Edition
98
Æ Press one of the start keys (white) when prompted with "Press start key".
(The start keys are located on the input side, output side and on the control panels on the left
and right sides of the station.)
A reference sequence is executed on all axes. The station is ready for operation after the ref-
erence sequence has completed.
The symbol is displayed in the work area of the user interface.
3
3
3
3.1.4 "Switching on the SIPLACE line" flow chart
The following flow chart shows the actions executed be the line computer, station and operator
while the SIPLACE line is being switched on and started up. 3
3