EUS0153210_YFact_Standard_E.pdf - 第169页

3-49 3 Board Editor n Board Graphic View Offset dialog You can change Offset Value from Board Graphic View Offset dialog Board Graphic View Offset dialog 64374-S0-00 Whenthedialogisclosedbypushingthe[OK]buttona…

100%1 / 238
3-48
3
Board Editor
n
Change Offset Value
To change the offset value, it operates it as follows.
n
Display Board Graphic View Offset dialog
Select“View”-“BoardGraphicViewOffset”menu,andthentheBoardGraphicViewOffsetdialogisopened.
“View” - “Board Graphic View Offset” Menu
64371-S0-00
Opened Board Graphic View Offset dialog
64372-S0-00
Or,itisabletoopentheBoardGraphicViewOffsetdialogbypushingthe[BoardGraphicViewOffset]button.
[Board Graphic View Offset] Button
64373-S0-00
3-49
3
Board Editor
n
Board Graphic View Offset dialog
You can change Offset Value from Board Graphic View Offset dialog
Board Graphic View Offset dialog
64374-S0-00
Whenthedialogisclosedbypushingthe[OK]buttonafterchanging,theoffsetvalueafteritchangingis
reflected in a Graphic View.
There are two kinds of offset values (based the Edge Clamp and the Locate Pin) displayed here.
It is different which to be used according to each machine uses the method of fixing which substrate.
Board Fix Device
64375-S0-00
However,when“LocatePin”settingonthe“MachineProperty”is“None”(itis“MachineInformation”-
“InstallationSetting”),theOffsetValue-“EdgeClamp”isusedalways.
“Machine Information” - “Locate Pin” Exist / None
64376-S0-00
3-50
3
Board Editor
n
Examples of changing Offset value
The following figure is a graphic view that makes the offset value (5mm, 5mm).
The larger part is located at the center of board and parts are located at the origin position.
Offset (5mm, 5mm)
64377-S0-10
It is shown to be arranged at the position of (5mm, 5mm) while selecting parts at the starting point position
when seen from the substrate coordinates.
The following figure is a graphic view that makes the offset value (0mm, 0mm).
The coordinates are different though parts are arranged at the center of the substrate similarly.
Offset (0mm, 0mm)
64378-S0-10
Moreover, parts at the starting point position are arranged in (0,0) on the substrate.