00193922-01.pdf - 第215页
User Manual SIPLAC E HF Series 5 Tasks on the m achine Software Vers ion SR.505.xx 05/2004 US Edition 5.3 Carrying out a walk-through inspe ction 215 5 Fig. 5.3 - 2 Dividing plates in the t ape container (1) Guide r ail …
5 Tasks on the machine User Manual SIPLACE HF Series
5.3 Carrying out a walk-through inspection Software Version SR.505.xx 05/2004 US Edition
214
5.3.3 Splicing the tape in good time
PLEASE NOTE:
Splice the tapes early enough so that the feeders do not become empty. Otherwise you will
experience prolonged down times.
However, do not splice the tapes too early because if you wind the end of the old tape onto
the new reel after splicing, the reel holding the new tape may become overfilled and the tape
will slip off the reel and become tangled up. This will again result in pick-up errors and pro-
longed down times. 5
5.3.4 Inserting dividing plates in the tape container
Æ
Insert the dividing plates as shown in Fig. 5.3 - 2 and remember that the smallest division of the
tape container is a 2x division. This will help avoid placement errors.
Æ Check that the dividing plates engage in the same positions on the three guide rails. Otherwise
the dividing plate will be offset or bent.
User Manual SIPLACE HF Series 5 Tasks on the machine
Software Version SR.505.xx 05/2004 US Edition 5.3 Carrying out a walk-through inspection
215
5
Fig. 5.3 - 2 Dividing plates in the tape container
(1) Guide rail for the dividing plates
(2) Tape container
(3) Waste tape container
(4) Supporting rods for the dividing plates
(5) Dividing plate
5 Tasks on the machine User Manual SIPLACE HF Series
5.3 Carrying out a walk-through inspection Software Version SR.505.xx 05/2004 US Edition
216
5.3.5 Using spindles for large tape reels
Æ Insert spindles into the dividing plates when using large tape reels.
PLEASE NOTE
We recommend that you use spindles if the tape reel diameter exceeds 5". This will ensure that
the feeders operate reliably.
Fig. 5.3 - 3 Inserting spindles for large reels
5
(1) Component trolley
(2) Position of the spindles
(3) Dividing plate
(4) Spindle (enlarged)