00191297-02.pdf - 第330页

7 What should you do ... User Manual SIPLACE S -23 HM 7.10 What to note when r efilling components Software V ersion SR.405.xx 05/99 Issue 328 7.10 What to n ote when refilli ng component s The refill ing of compo nents …

User Manual SIPLACE S-23 HM 7 What should you do ...

Software Version SR.405.xx 05/99 Issue 7.9 How to avoid track errors

327

7.9.4 Component coordinate system and pick-up angle

Fig. 7.9 - 1 Position of the component and its pick-up angle

7 What should you do ... User Manual SIPLACE S-23 HM

7.10 What to note when refilling components Software Version SR.405.xx 05/99 Issue

328

7.10 What to note when refilling components

The refilling of components with and without a barcode is described in chapter 4, section 4.1. 7

È With tape feeder modules, make sure that you always splice on a new tape early enough so

that the feeder modules do not run out of components.

È However, do not splice the tapes too early because if you wind the tape onto the new reel after

splicing the end of the old tape, the reel with the new tape may be over-filled. The tape could

then slip off the reel and become tangled. Under certain circumstances, this could cause pick-

up errors and prolonged down times.

È Always insert shafts when using large tape reels and make sure that the dividing plates are

inserted correctly (see Fig. 7.5 - 2).

User Manual SIPLACE S-23 HM 7 What should you do ...

Software Version SR.405.xx 05/99 Issue 7.11 Tools for the operator

329

7.11 Tools for the operator

All operators are to be equipped with the tools listed in the following. It is recommended to store

the tools in an appropriate container to avoid being injured when removing the tools from the con-

tainer (i.e. by a pair of tweezers). 7

Every operator of the machine requires: 7

– SMD tweezers

– A brush with short bristles to clean the component tables

– A set of small regular and Phillips-head screwdrivers

– A tape splicing clamp and splicing materials

– Scissors for splicing tape (do not use multi-purpose scissors or diagonal cutters)

– Erasers or fiberglass pens to remove fiducials

– Indelible pens for marking the tracks

– Cleaning agents (ethyl alcohol, Plexiglass cleaner, cotton wool tips, lint-free cloths, pipe-

cleaners)

– WD40 corrosion protection

– Vacuum cleaner