ACT - Accuracy Check Tool.pdf - 第153页

ACT with SSW 7xx / User Manual 07/2017 Edition 45 4.1.3.2 Pass -through If there are mult iple machines in the l ine, the ACT plat e has to be transporte d through single machines either befo re or after the mac hine to …

100%1 / 220
ACT with SSW 7xx / User Manual 07/2017 Edition
44
4.1.3.1 Creating the Setup – Tray Changer (TC)
The ACT tray may be used, but has to be positioned in line with the waffle-pack tray carrier (WTC,
tray holder).
Some examples can be found in SIPLACE Pro under My tables \ ACT \ TC \.
CAUTION
In order to place the ACT tray mechanically safe, it has to be positioned at the stop on
the side without pockets. It can be fastened with two holding magnets (see the marker in
Figure 4-13).
In SIPLACE Pro under My waffle-pack trays \ ACT \ xxx_L ; xxx_R the tray has to be set-up on the
waffle-pack tray carrier depending on if the tray changer has a left or a right stop.
Overview of tray changers with left and right stops
Tray changer Where is the stop?
WPC4 Left ( ACT \ xxx_L)
WPC4 – SIPLACE D3 Left ( ACT \ xxx_L)
WPC 5 Right ( ACT \ xxx_R)
WPC 6 Right ( ACT \ xxx_R)
MTC2 Left ( ACT \ xxx_L)
Table 4-6: Tray changers with left or right stops
FMT WPC4
Left ( ACT \ xxx_L)
FMT WPC5 + WPC6
Right ( ACT \ xxx_R)
MTC2
Left ( ACT \ xxx_L
Figure 4-13: ACT tray on waffle-pack tray carrier
ACT with SSW 7xx / User Manual 07/2017 Edition
45
4.1.3.2 Pass-through
If there are multiple machines in the line, the ACT plate has to be transported through single
machines either before or after the machine to be measured.
The Pass-through function can be activated and deactivated in the setup of the respective station.
Figure 4-14: Pass-through function
Figure 4-15: Specification in Line Control GUI with DX4 in Pass-Through mode
4.1.3.3 Tray in Conveyor for ACT Option
A detailed description of the Tray in Conveyor for ACT option can be found in chapter 5.
ACT with SSW 7xx / User Manual 07/2017 Edition
46
4.2 Measuring with the ACT at the Station
You have already specified the placement and measurement programs at the station as described
in section 4.1.
► Now set up the components on the station.
4.2.1 Setting Up Components on the Component Table
► Open the machine cover.
► Place the manual waffle pack tray carrier or the feeder onto the specified tracks of the relevant
location.
Example of the position of manual waffle pack tray carrier with glass components for a
SIPLACE X3
NOTICE
The waffle pack tray carrier on an X machine or SX machine with an X-table must be on
track 21 (Figure 4-16
). Therefore, the waffle pack tray occupies track 7 to 35
(Figure 4-17).
NOTICE
Before you undock an X-table with a set ACT tray you should remove the ACT tray or
push it back under the centering / comb bar. Otherwise, it may get stuck in the tape
removal channel and get damaged.
Key:
(1) Waffle pack tray (3) X-table
(2) X table holder (4) Track 21
Figure 4-16: Position (track 21) of waffle pack tray carrier on X table