ACT - Accuracy Check Tool.pdf - 第161页
ACT with SSW 7xx / User Manual 07/2017 Edition 53 4.2.4 Loading the Plate into the Measuring M achine 4.2.4.1 X- Series On the SIPLACE X- series machines the glass plate can be inserte d into the conv eyor by opening the…
ACT with SSW 7xx / User Manual 07/2017 Edition
52
NOTICE
► Check the orientation of the inserted plate if you see the following error message
(ACT cross cannot be measured).
Figure 4-24: Error message caused by faultily inserted plate; example SW 705
ACT with SSW 7xx / User Manual 07/2017 Edition
53
4.2.4 Loading the Plate into the Measuring Machine
4.2.4.1 X-Series
On the SIPLACE X-series machines the glass plate can be inserted into the conveyor by opening
the covers of the input section (extension kit) or the machine cover.
► Insert the plate directly into the input section of the measuring machine so that the sensor is
activated.
► Press Start.
The board is automatically moved into the placement area and gets placed.
Thereafter, the measurement is automatically started, see section 4.2.5.
Figure 4-25 and Figure 4-26 show an assembled ACT plate, in one example with glass
components and in the other with ceramic components.
Figure 4-25: Measuring plate with placed glass comp. Figure 4-26: Measuring plate with placed ceramic comp.
4.2.4.2 SX-Series and DX-Series
On the SIPLACE SX- and DX-series machines the reachability to insert the plate in the input
section is limited, particularly on machines that are placed in the middle or at the end of a line.
Therefore, the plate has to be inserted at the first machine of the line.
► Press Start.
► Insert the plate up to 50%+x into the input section of the first machine.
► Click on the Conveyor interface button directly under the conveyor in the station software
(see Figure 4-27).
Figure 4-27: Conveyor interface button
ACT with SSW 7xx / User Manual 07/2017 Edition
54
Figure 4-28: Conveyor interface window
► Select LP einfahren (Loading PCB).
► Click OK.
If this is not the placement station on which the ACT is to be performed, the plate is automatically
passed through the machine, since there is no specification by SIPLACE Pro for components to be
placed.
If no components are to be placed on the next machine either, the plate is automatically passed
through this machine, too.
On the station being in ACT mode and for which a corresponding specification for components to
be placed is available, the plate is stopped and gets placed automatically in the placement area,
see section 4.2.5.
Then the measurement is started automatically.