00195440-05-SG_D-Series_FSE-EN.pdf - 第108页

6 Reference Run 6.3 Room for Your Sketches and Notes 6.2.4 Height Reference Run 108 Student Guide SIPLACE D-Series (FSE) 6.3 6 . 3 R o o m f o r Y o u r S k e t c h e s a n d N o t e s Room for Your Sketches and Notes

6 Reference Run

6.2.4 Height Reference Run 6.2 P&P Reference Run

Student Guide SIPLACE D-Series (FSE) 107

6.2.4

6.2.4 Height Reference Run

Height Reference Run

Measure nozzle height

With this function we check the correct nozzle type which

is programmed. The nozzle length is taken to calculate

the pick up and placement height for the following place-

ments.

Legend

1. Top of fixed conveyor side

2. Z motor

3. Vacuum - air blast distribution

► The gantry moves the placement heads above the

fixed conveyor side.

► The Z axis positions module 2 (X/D3 machine) down-

wards.

► The travel range of the Z axis is taken to calculate the

Twin head height in relation to the nozzle type.

► Now the same happen with module 1.

► The maximum length tolerance is 0,4 mm: If the

length difference is too high an error message is dis-

played.

NOTICE

Both modules are measured at the same position of the PCB conveyor!

This Twin head reference run is performed parallel to the C&P head reference run in the other

placement area.

6 Reference Run

6.3 Room for Your Sketches and Notes 6.2.4 Height Reference Run

108 Student Guide SIPLACE D-Series (FSE)

6.3

6.3 Room for Your Sketches and Notes

Room for Your Sketches and Notes

6 Reference Run

6.2.4 Height Reference Run 6.3 Room for Your Sketches and Notes

Student Guide SIPLACE D-Series (FSE) 109