00196602-05_SM_SIPLACE_X-Feeder_EN.pdf - 第86页
6 Repairing the X Feeder modules 6.7 Operating Panel Assembly 86 Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017 Example diagram for X feeder modules with 16mm width ► Fix the mushroom head cutting screws marked in th…
6 Repairing the X Feeder modules
6.7 Operating Panel Assembly
Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017 85
► (1) Insert the flat ribbon cable into the connection,
as far as the stop.
Make sure that the blue surface at the end of the
cable is at the top and that the flat ribbon cable
lies straight in the connection.
► Swing the lock on the connection down onto the
flat ribbon cable.
Make sure that the flat ribbon cable is fitted firmly
in the connection. Tug gently on the cable to
check.
► Check again whether the flat ribbon cable is fitted
straight in the connection.
If necessary, open the lock and correct the posi-
tion of the cable before closing the lock again.
► (2) and (3)
Carefully insert the connector in the direction of
the arrow, as far as the stop, into the connection
shown.
Make sure that the smooth side of the connector
is at the top.
CAUTION!
Do not push the connector with force into the
connection, otherwise individual pins may
break off or be distorted.
.
► (4) Insert the other connector into the connection
marked in the diagram.
► Fit the left side cover into place (see 6.3.2 "Fitting
the Left Side Cover" [}24]).
► Carefully place the feeder module down on its left
side.
► Position the foil container so that it is aligned
against the side cover.
6 Repairing the X Feeder modules
6.7 Operating Panel Assembly
86 Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017
Example diagram for X feeder modules with 16mm
width
► Fix the mushroom head cutting screws marked in
the diagram (2.5 x 7.5mm Torx).
Example diagram for X feeder modules with 24-88mm
width
► Loosen the screws marked in the diagram.
(1) Mushroom head cutting screw (2.5x7.5mm)
Torx
(2) Cylinder head Phillips screw (2.5x5mm)
► Now fit the rocker (see 6.6.2.2 "Fitting the Rocker
(4 - 88 mm)" [}70]).
6 Repairing the X Feeder modules
6.8 Leaf Spring
Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017 87
6.8 Leaf Spring
Required spare parts
Fig.5: Example: leaf spring 8mm (top) and 24mm (bottom)
Feeder module Item no. Designation
4+ 8mm 03008284-Sxx Leaf spring/foil disposal X8
12 mm 03009283-Sxx Leaf spring/foil disposal X12
16–88mm 03022105-Sxx Leaf spring/foil disposal X16 - 88
6.8.1 Removing/Fitting the Leaf Spring (4 - 12 mm)
► Remove the left side cover (see 6.3.1 "Removing
the Left Side Cover" [}23]).
► Lift the leaf spring straight up and out of the hold-
ing device.
► Insert the leaf spring vertically (from above) into
the holding device.
► Hook the end of the leaf spring in behind the
marked holder.
► Fit the left side cover into place (see 6.3.2 "Fitting
the Left Side Cover" [}24]).