User Manual E-by-SIPLACE 用户手册.pdf - 第235页

User manual E by SIPLACE 5 Working with the machine From software version SC 712.1 Edition 05/2019 5.11 Setting up t he feeder modules 235 5.11.3 Using the SI PLACE SmartFeeder E 5.11.3.1 Check the SIPLACE SmartFeeder E …

5 Working with the machine User manual E by SIPLACE

5.11 Setting up the feeder modules From software version SC 712.1 Edition 05/2019

234

On standby, the status display (item 2) lights up green if the feeder module is contained in the cur-

rent setup. If the feeder module is not contained in the current setup, the status display remains

off.

The SIPLACE SmartFeeder E is locked in position in the changeover table by a latch. The proce-

dure for removing feeder modules from the changeover table is as follows:

 Pull the removal handle (item 1). The status display goes red and then the status display

goes out.

 Use the removal handle to pull the feeder module out of the locking bar (item 3) and stop

bar (item 4).

 Remove the feeder module. Pay attention to the centering bar (item 5).

User manual E by SIPLACE 5 Working with the machine

From software version SC 712.1 Edition 05/2019 5.11 Setting up the feeder modules

235

5.11.3 Using the SIPLACE SmartFeeder E

5.11.3.1 Check the SIPLACE SmartFeeder E before using it

Fig. 5.11 - 2 Check the SIPLACE SmartFeeder E before using it

(1) Cover foil rocker

(2) Pickup window

(3) Lever for raising and latching the pick-up window

Check the following points before you use a feeder module on the changeover table:

 The feeder module must be in perfect condition.

 Tap the cover foil rocker (item 1) lightly to make sure that it has not jammed.

 Check that the area around the pickup window (item 2) is free from loose components.

 Press the lever (item 3) forward slightly to open the pickup window (item 2). This will raise the

pick-up window slightly.

PLEASE NOTE

The tensioned cover foil continues to transport the tape when the tape has been inserted

and exposes the components.

 Do not press the lever if a component tape is inserted.

(1)

(2)

(3)

5 Working with the machine User manual E by SIPLACE

5.11 Setting up the feeder modules From software version SC 712.1 Edition 05/2019

236

 Close the pickup window (item 2), by returning the lever (item 3) to its original position.

 Remove loose components from the changeover table with a brush or use a vacuum

cleaner with appropriate nozzle.

PLEASE NOTE

 If the component tape is already inserted, cut it off flush with the front edge of the

feeder module.