Printer 600 Machine Programming.pdf - 第40页
0$&+,1( 352*5$00 ,1* 67$*(& '(',& $7('722/ ,1* 1.40 User Manual Software Ve rsion 07SP04 42. Remove the b oard fr om the rails. 43. Select Conti nue (F1). 44. Either: a. Open the front p…
0$&+,1(352*5$00,1*
67$*(&'(',&$7('722/,1*
Software Version 07SP04 User Manual 1.39
34.Either:
a. Open the front printhead cover.
or
b. Raise the printhead shutter.
35.Check that the setup of the tooling is adequate for the board, adjust as
necessary.
NOTE
If adjustment is required, this can be carried out at Transport Height.
36.Either:
a. Close the front printhead cover.
or
b. Lower the printhead shutter.
37.Press the System button.
38.Select Exit (F8).
39.Select Exit (F8).
The following window and menu bar is displayed:
40.Select Continue (F1).
41.Select Auto Board (F1). The message ‘Board on rails, remove and
continue’ is displayed.
Exit
Vision
Height
Open
Cover
Exit
Leaving Generic Tooling
WARNING You are about to return
to the Setup Page
Clear all tooling setup
equipment before proceeding
Continue Exit
Continue Exit
Auto
Board
Manual
Board
0$&+,1(352*5$00,1*
67$*(&'(',&$7('722/,1*
1.40 User Manual Software Version 07SP04
42.Remove the board from the rails.
43.Select Continue (F1).
44.Either:
a. Open the front printhead cover.
or
b. Raise the printhead shutter and lower the drop down panel.
45.To adjust the width of the chase rails to accommodate the stencil for the
product file loaded, carry out the following (ASM only):
a. Press and hold the left hand chase rail push button valve.
b. Slide the left hand chase rail to the desired position indicated on the
graduated scale.
c. Release the push button valve.
d. Repeat the procedure for the right hand chase rail.
46.If the stencil size is less than 29″ x 29″ the screen depth adjuster position is
to be adjusted as follows (ASM only):
Continue
Open
Cover
0$&+,1(352*5$00,1*
67$*(&'(',&$7('722/,1*
Software Version 07SP04 User Manual 1.41
a. Slide the screen depth adjuster towards the front of the machine.
b. Lift the adjuster clear of the two locating screws.
c. Using the inner pair of keyway slots locate the adjuster on the chase and
slide the adjuster to the rear of the machine to lock in place.
47.Ensuring for the correct orientation of the stencil, load the stencil against the
left hand chase rail.
48.If fitted, toggle screen clamp switch to down position (on).
49.Either:
a. Close the front printhead cover.
or
b. Raise the drop down panel and lower the printhead shutter.