QP132三级参考手册.pdf.pdf - 第102页

8.1.5 Pallet Pass Through Check Sensor 1. Press [SET] → [MANUAL] → [I/O] → [STANDARD I/O] → [OUTPUT] and turn on Y04E P.IN RSFT to move the 10 mm shift cylinder to the forward end position. 2. Place a pallet against the …

100%1 / 136
8.1.4 Pallet Arrival Check Sensor
1. Press [SET] → [MANUAL] → [I/O] → [STANDARD I/O] → [OUTPUT]
and turn on Y04B SS PLT BWD to retract the Pallet shift.
2. Place the jig (CGPJ0020) against the stopper and press [SET] →
[MANUAL] → [I/O] → [STANDARD I/O] → [OUTPUT] and use Y04C
SS PLT UCLP to clamp the jig.
3. Move the sensor 1 mm toward the jig and adjust the sensitivity.
QP132T8002
Pallet arrival check sensor
Pallet pass-
through check
Chapter 8 8.1 In Shifter Adjustment
Edition 1.1 8-3 QP-132 Level 3 Tutorial
8.1.5 Pallet Pass Through Check Sensor
1. Press [SET] → [MANUAL] → [I/O] → [STANDARD I/O] → [OUTPUT]
and turn on Y04E P.IN RSFT to move the 10 mm shift cylinder to the
forward end position.
2. Place a pallet against the 10 mm shift cylinder.
3. Move the sensor to the position where the pass-through check sensor
senses the pallet.
4. Move the sensor 1 mm to the left. The sensor must turn ON at this
position.
5. Ensure that the right edge of the pass-through check sensor is not
beyond the right edge of the IN- pallet loader. If so, shift it to the left.
6. Turn off Y04E P.IN RSFT to return the pallet and check that the sensor is
not interrupted. Adjust the sensor’s sensitivity later when pallets are
loaded onto the machine.
Chapter 8 8.1 In Shifter Adjustment
Edition 1.1 8-4 QP-132 Level 3 Tutorial
8.1.6 Pallet Shift
1. Adjust the forward end speed controller of the pallet OUT cylinder to 4.5
turns from the fully closed position.
2. Press [SET] → [MANUAL] → [I/O] → [STANDARD I/O] → [OUTPUT]
and turn on Y04B P.IN PLT BWD to move the IN- pallet shift cylinder to
the backward end.
3. Place a pallet against the 10 mm shift cylinder.
4. Turn on Y04C P.IN UCLP to unclamp the IN- pallet loader clamp.
5. Turn off Y04E P.IN PLT RSFT to move the 10 mm shift cylinder to the
backward end.
6. Remove the top cover of the return conveyor.
7. Remove the air hose connected to the solenoid valve.
8. Adjust the forward end bracket so that the pallet holder will be in
contact with the 10 mm shift cylinder stopper when the cylinder is
advanced.
Chapter 8 8.1 In Shifter Adjustment
Edition 1.1 8-5 QP-132 Level 3 Tutorial