QP132三级参考手册.pdf.pdf - 第69页
4.5.2 Program Origin Note: Module style and mechanical stroke on the X-axis is different between the X No. 4 ~ 12 and No.13 and later. Same adjustment method is available for both types. However, the values are different…
8. PY04 NZL A DOWN to lower the holder A.
9. Move the head manually. Place the nozzle jig softly on to the dial
indicator.
10. Adjust the head height. Make sure that the head is not tilting.
11. Check holders B, C and D heights using a dial indicator. Obtain the
average height for all four. Finalize the head height. The deviation of
the four heights shall be less than ± 0.06 mm.
0
Average
height
SS-rail top
Obtain the average height
and adjust the height by a
dial indicator to finalize.
Holder, D
Holder, C
Holder, B
Holder, A
QP132T4008
Chapter 4 4.5 Measuring PM Proper Data and Adjustment
Edition 1.1 4-12 QP-132 Level 3 Tutorial
4.5.2 Program Origin
Note: Module style and mechanical stroke on the X-axis is different between the X No. 4 ~ 12
and No.13 and later. Same adjustment method is available for both types. However, the
values are different.
1. Press the EMERGENCY STOP button to shutdown the 200V.
2. Attach a nozzle jig (ACGPJ9021) to holder A.
3. Set the X0, Y0 calibration jig (ACGPJ9030) on the 8-inch pallet.
4. Ensure that the SS-axis is at the SS0 position and set the 8-inch pallet to
the module.
5. Press [SET] → [MANUAL] → [I/O] → [STANDARD I/O] → [OUTPUT]
and Y061 SS PLT UCLP to unclamp.
6. Press Y062 SS PIN ON to turn on the SS pin.
7. Position the pallet holder to the SS-rail cam follower.
8. Press Y060 SS PLT CLP to clamp the pallet.
9. Move the head manually to the position where the nozzle jig goes
smoothly into the hole of the X0,Y0 calibration jig.
10. Press [SET] → [PROPER] → ID No. → [PM] → [Select the module] →
[FINISH] → [X/Y] → [X0/Y0] → [SET] to enter the Proper data.
QP132T4009
Holder A
Nozzle jig
X0, Y0 calibration jig
8-inch pallet
SS-rail
Chapter 4 4.5 Measuring PM Proper Data and Adjustment
Edition 1.1 4-13 QP-132 Level 3 Tutorial
Notes:
Chapter 4 4.5 Measuring PM Proper Data and Adjustment
Edition 1.1 4-14 QP-132 Level 3 Tutorial