QP132三级参考手册.pdf.pdf - 第53页

6. The SS-pin is positioned to the jig on the left side and SS0 is where the dial begins to move. 7. Keep the SS-axis position and press [SET] → [PROPER] → [MAIN] → [UNIT] → [SS] → [SSD] → [SET]. If the machine is in mec…

3.2 Measuring SS-Axis Proper Data and

Adjustment

3.2.1 Step Slide Origin SS

1. Complete the adjustment for the SS-axis zero set and overtravel sensors.

2. Move the SS-axis to the plus side slightly.

3. Set SS0 jig (CGPJ0010) to the LM guide as illustrated below.

4. Place a dial gauge as shown.

5. Move the SS-axis in the minus direction using the inching keys at low

speed.

QP132T3002

Set a dial gauge

to this surface of jig.

SS pin

N-shift

M guide

SS0

calibration jig

Side view

Put jig on the LM

guide to place.

Chapter 3 3.2 Measuring SS-Axis Proper Data and Adjustment

Edition 1.1 3-3 QP-132 Level 3 Tutorial

6. The SS-pin is positioned to the jig on the left side and SS0 is where the

dial begins to move.

7. Keep the SS-axis position and press [SET] → [PROPER] → [MAIN] →

[UNIT] → [SS] → [SSD] → [SET]. If the machine is in mechanical check

mode, enter the value to F4G/FujiCam, and transmit the Proper data to

the machine.

SS0 is where the SS-axis

contacts with the jig.

SS0 is where the

indicator starts

moving.

QP132T3003

Chapter 3 3.2 Measuring SS-Axis Proper Data and Adjustment

Edition 1.1 3-4 QP-132 Level 3 Tutorial

3.3 Training Evaluation

Circle the most appropriate answer from the list below.

(1) To measure SSO, which jig and tools are required?

a. SSO jig and feeler gauge

b. SSO jig and dial gauge

c. All of the above.

(2) After replacing the SS0 motor, zero set:

a. without the timing belt.

b. with the timing belt attached.

c. with the timing belt attached but no tension applied.

(3) SS0 is the position where:

a. the SS motor count is 0.

b. the pallet is loaded.

c. Both a and b above.

(4) SS-axis timing belt tension is:

a. 73 ± 10 Hz

b. 75 ± 5 Hz

c. 75 ± 10 Hz

(5) SS stands for:

a. Step Style

b. Slight Step

c. Step Slide

Chapter 3 3.3 Training Evaluation

Edition 1.0 3-5 QP-132 Level 3 Tutorial