QP132三级参考手册.pdf.pdf - 第54页
3.3 T raining Evaluation Circle the most appropriate answer from the list below. (1) To measure SSO, which jig and tools are required? a. SSO jig and feeler gauge b. SSO jig and dial gauge c. All of the above. (2) After …
6. The SS-pin is positioned to the jig on the left side and SS0 is where the
dial begins to move.
7. Keep the SS-axis position and press [SET] → [PROPER] → [MAIN] →
[UNIT] → [SS] → [SSD] → [SET]. If the machine is in mechanical check
mode, enter the value to F4G/FujiCam, and transmit the Proper data to
the machine.
SS0 is where the SS-axis
contacts with the jig.
SS0 is where the
indicator starts
moving.
QP132T3003
Chapter 3 3.2 Measuring SS-Axis Proper Data and Adjustment
Edition 1.1 3-4 QP-132 Level 3 Tutorial
3.3 Training Evaluation
Circle the most appropriate answer from the list below.
(1) To measure SSO, which jig and tools are required?
a. SSO jig and feeler gauge
b. SSO jig and dial gauge
c. All of the above.
(2) After replacing the SS0 motor, zero set:
a. without the timing belt.
b. with the timing belt attached.
c. with the timing belt attached but no tension applied.
(3) SS0 is the position where:
a. the SS motor count is 0.
b. the pallet is loaded.
c. Both a and b above.
(4) SS-axis timing belt tension is:
a. 73 ± 10 Hz
b. 75 ± 5 Hz
c. 75 ± 10 Hz
(5) SS stands for:
a. Step Style
b. Slight Step
c. Step Slide
Chapter 3 3.3 Training Evaluation
Edition 1.0 3-5 QP-132 Level 3 Tutorial
Notes:
Chapter 3 3.3 Training Evaluation
Edition 1.0 3-6 QP-132 Level 3 Tutorial