00197187-01_AI_LBO_SX12_ab_09-2011_FS02_de_en.pdf - 第57页
Fitting the Long Board Option Final Work Long Board Option 57 3.8 Final Work ► Fasten any loose cables with cable ties, wher e required. ► Repeat the entire conversion pro cedure on lane 2 of the dual co nv eyor, if us e…
Fitting the Long Board Option
PCB Support
56 Long Board Option
► Position the required PCB supports in the front area of the lifting table plate.
The shorter PCB supports are each in the vicinity of the conveyor sides.
The longer PCB supports are to be positioned exactly in the centre, between the two conveyor sides,
so that any board warpage can be replicated.
Perform a test:
► Move a board with significant curvature (warpage) into the conveyor.
► Clamp the board into place.
► Open the cover and press the board to test. The PCB support must lie against the board or push
slightly against it to make it curve up.
See also
4.1 Setting the Parallelism and Height of the Lifting Table Plate [ ➙ 59]
Fitting the Long Board Option
Final Work
Long Board Option 57
3.8 Final Work
► Fasten any loose cables with cable ties, where required.
► Repeat the entire conversion procedure on lane 2 of the dual conveyor, if used.
► Fit the new cover sheets onto the sensor rails.
- cover 2 right stopper rail LBO SX12 [03091990-xx]
- cover 2 left stopper rail LBO SX12 [03091991-xx]
► Switch on the machine
► Calibrate the lifting table motors. (See Calibrating the Lifting Table Motors in SX1/2 Conveyors)
The lifting table motors need to be calibrated due to the weight of the new lifting table plates.
► Perform a stopper test.
Enabling the LB option
CAUTION
Take care not to damage the cables.
► Always make sure that the cables do not rub against any parts, are not pinched or folded.
► Enable the license for this option on the SIPLACE-
PRO line computer. The license key can be obtained
from the ASM-AS internet license portal, using the
"Long Board MC" [00116710-01] certificate provided.
If you should have any questions about the license,
contact your SIPLACE Service team.
