User-Manual-of-NeoDen4-PNP-machine.pdf - 第34页
29 Figure 4. 30 e. Move the no zzle to any place o f PCB board, put one p iece of carbon pa per, then c lick “Tra il”, nozzle will rotate and leave a dot on the carbo n, after that click the “Len s alignmen t”, Focu s th…
28
(4) Click the central point among four nozzles under the shot can set the central point.
(5) Another way is pressing CTRL button then click the mouse to make each nozzle to identify their
own central point in the four quadrants.
(Notice: Please click the LENS ROTATION before setting the suction nozzle, then PnP machine
will collect nozzle’s 360-degree rotation photos to synthesize. After that, press CTRL button to set
each nozzle’s identification of central point.)
(6) Save it after finishing the setting.
Correct nozzle 1~nozzle 4 separately.
Click “click to align” and go into interface below, see the Figure 4.29.
Figure 4.29
(7) Operation steps:
a. Click the button of “LENS ROTATION” to let machine take photos of nozzle’s 360-degree
rotation.
b. Click the central point of nozzle
c. Click the save button.
d.Nozzle1 and camera relative position: it is for the synchronism of nozzle and camera, setting it
when placement position does not match with the camera position.
Click “click to align” then go into interface below, see the Figure 4.30.
29
Figure 4.30
e. Move the nozzle to any place of PCB board, put one piece of carbon paper, then click “Trail”,
nozzle will rotate and leave a dot on the carbon, after that click the “Lens alignment”, Focus that dot
and save, it will be done (show as photo above).
(8) Trash box position: setting the position of dropping component, it depends.
(9) Angel Correction of upward-looking camera
Click “Click to align” and enter into upward-looking cameras angle correction interface.
The vision interface will lock at 3rd nozzle
30
Move down the nozzles with 7mm and make sure in the vision interface it can shows with 2 nozzles
pictures.