00197279-03_SM_Glue-Feeder_EN.pdf - 第32页
Replacing Spare Parts Cartridge Pipe 3.11.2 Fitting the Cartridge Pipe 32 Service Manual SIPLACE Glue Feeder 3.11.2 3 . 1 1 . 2 F it t in g t h e C a r t r id g e P ip e Fitting the Cartridge Pipe CAUTION Poisonous and h…
Replacing Spare Parts
3.11.1 Removing the Cartridge Pipe Cartridge Pipe
Service Manual SIPLACE Glue Feeder 31
► Position the two lugs of the special tool into the two
holes in the union nut.
► Loosen the union nut by turning it anticlockwise.
► Remove the union nut.
► Remove the nozzle heating.
► Hold the cartridge pipe tight with one hand.
► Loosen the screwed connection with the help of an 8
mm open-ended wrench.
► Remove the cartridge pipe.
Replacing Spare Parts
Cartridge Pipe 3.11.2 Fitting the Cartridge Pipe
32 Service Manual SIPLACE Glue Feeder
3.11.2
3.11.2 Fitting the Cartridge Pipe
Fitting the Cartridge Pipe
CAUTION
Poisonous and hazardous substances
To avoid direct contact with the glue, always wear protective gloves during this work.
► Place the cartridge pipe from behind onto the thread
of the jet block.
► Use a size 8 mm open-ended wrench to loosely fas
-
ten the cartridge pipe in a clockwise direction.
► Align the cartridge pipe centrally and straight in rela
-
tion to the back, so that the cartridge can be correctly
screwed into place.
► Fix the cartridge pipe with one hand in this position
and then screw the lock tight.
► Make sure that the dispenser nozzle is centered on
the jet block thread.
► Place the nozzle heating onto the jet block and align
this straight on the feed pipe.
► Fit the union nut onto the dispenser nozzle.
► Position the two lugs of the special tool into the two
holes in the union nut.
► Tighten the union nut by turning it clockwise.
Replacing Spare Parts
3.11.2 Fitting the Cartridge Pipe Cartridge Pipe
Service Manual SIPLACE Glue Feeder 33
► Insert the heating connector into the nozzle heating,
up to the stop.
► Hold the cartridge against the cartridge pipe and
screw it on to the pipe straight.
► Fit the cartridge adapter at the straight points onto the
back of the cartridge and press on as far as the stop.