00193697-01.pdf - 第98页
8 New functionality in 504.01 SIPLACE Software Guide SR.504.xx 8.17 FiFo option f or each location Issue 01/03 EN 98 8.17 FiFo option for each location If an MTC is attached to the mach ine, the F iFo pick up strateg y m…
SIPLACE Software Guide SR.504.xx 8 New functionality in 504.01
Issue 01/03 EN 8.15 OIS
97
8.15 OIS
The software version OIS 2.2 supports the SIPLACE HF machine. 8
NOTE
A detailed description of the software option OIS 2.2 can be found in the instructions "Getting
started with OIS 2.2“ and the OIS 2.2 online Help system. 8
8.16 Fine calibration
The functionality has been enhanced compared with version 502 of the software and covers the
following Twin Head features: 8
– Placing and measuring an entire Twin Head panel (24 components per segment)
– Placing and measuring a single Twin Head segment panel (48 components per segment)
– A combination of the two scenarios above with any stationary component camera
– Recording and incorporation of segment-specific offsets for the Twin Head
– Used IC camera CC02-05, FC camera CC07-500
Fine calibration can be called with Options--> Fine calibration mode.... 8
8
Fig. 8.16 - 1 "Fine calibration" dialog box
8 New functionality in 504.01 SIPLACE Software Guide SR.504.xx
8.17 FiFo option for each location Issue 01/03 EN
98
8.17 FiFo option for each location
If an MTC is attached to the machine, the FiFo pickup strategy may or may not be used to pick up
components (First in First out: The first components stored in the MTC are the first components
to be placed). In the past (version 502 of the software), this setting applied to the entire machine.
Thus, the machine option setting applied to all MTCs attached to a given machine. 8
As of version 504 of the software, this option can be activated on a location-by-location basis on
a SIPLACE HF with MTC 2. The FiFo option now appears in the machine options for the various
processing areas depending whether an MTC is attached. 8
The Machine options dialog box can show up to 4 options (for a SIPLACE HF only locations 2
and 4: 8
– MTC 1: Component pickup strategy: FiFo
– MTC 2: Component pickup strategy: FiFo
– MTC 3: Component pickup strategy: FiFo
– MTC 4: Component pickup strategy: FiFo
8
Fig. 8.17 - 1 FiFo machine options
The options are only visible if an MTC is attached. 8
8
SIPLACE Software Guide SR.504.xx 8 New functionality in 504.01
Issue 01/03 EN 8.17 FiFo option for each location
99
NOTE
The selected option will be retained even if the machine is switched on and off.
When the software is first installed, the FiFo option is deactivated. 8
The corresponding option is shown in the "Matrix Tray Changer" view: 8
8
Fig. 8.17 - 2 "Matrix Tray Changer" view
8
8