00191374-04.pdf - 第129页

Adjus t ment In str uc tio ns SI PLA CE HS- 50 6 Gantries Edition 12/00 6.6 Calibrat ion of the Anti - Crash Board 129  &DOLEUDWLRQRIWKH$QWL&UDVK%RDUG  7 HVW(TXLSPHQW – Di gital m ultime ter – SI …

100%1 / 186
6 Gantries Adjustment Instructions SIPLACE HS-50
6.5 Dynamic Adjustment of the X- and Y- Axes Edition 12/00
128
Sollwert /
Vnominal
Positionsabweichung /
deviation of position
Stromsollwert /
nominal current
Endemeldung /
end signal
Adjustment Instructions SIPLACE HS-50 6 Gantries
Edition 12/00 6.6 Calibration of the Anti - Crash Board
129
 &DOLEUDWLRQRIWKH$QWL&UDVK%RDUG
 7HVW(TXLSPHQW
– Digital multimeter
– SITEST software
– Anti - crash board for HS-50
 7HVW6HWXS
.(<
TP2 = Signal
R82, R92 = Potentiometer
TP1 = Signal
X
, Y = "Error" message for the axes of the left gantry in each work area.
X
, Y = "Error" message for the axes of the right gantry in each work area.
(Viewpoint from input conveyor).
DIS = Message: Distance sensor activated.
R 82
R 92
6 Gantries Adjustment Instructions SIPLACE HS-50
6.6 Calibration of the Anti - Crash Board Edition 12/00
130
NOTE
Adjustments are identical for both gantry groups.
CAUTION
Perform these adjustments only after you pressed the EMERGENCY STOP button!
 $GMXVWPHQWRI'LVWDQFH6HQVRU6HQVLWLYLW\
Å
Connect the digital multimeter of the anti - crash board to pin TP 0 (0V) and pin TP 1 (signal).
Å Move both gantries together.
Å Use the adjusting screw to set the voltage at the distance sensor to 6V - +/- 0,1 V.
Å Move the two gantries together until a distance of 100 mm is reached.
(Elastomer spring up to opposite plane).
– The voltage must reach a value of approx. 2V.
 &DOLEUDWLRQRIWKH$QWL&UDVK%RDUG
Å
Connect the digital multimeter to the anti - crash board at pin TP2 (signal) and pin TP0 (0V).
Å Move both gantries together.
Å Use the potentiometer R82 to adjust the voltage to 0V- +/- 0.05 V.
Å Move the two gantries together until a distance of 100 mm is reached.
Å Use the potentiometer R92 to adjust the voltage to 10V- +/- 0.05 V.
Å Check the 0V- setting one more time.
Å Repeat the calibration if the reached value is incorrect.
 )XQFWLRQ&RQWURORIWKH'LVWDQFH6HQVRU
 3UHSDUDWLRQ
Å Perform a reference run.
 7HVWLQJ3ODFHPHQW$UHDV,DQG,,
Å In placement area I, attach a piece of paper in the middle of the machine, at the height of the
distance sensor.