00191374-04.pdf - 第92页
5 Single and Dual PCB Conv eyor Adjustment Instructions S IPLACE HS-50 5.3 Adjustment of P roximity Switches of Lifting Tables Edition 12/00 92 $GMX VWPHQW R I 3 UR[LPLW\ 6ZLWFKHV RI /LIWLQJ 7 DEOHV Å Ad just …
Adjustment Instructions SIPLACE HS-50 5 Single and Dual PCB Conveyor
Edition 12/00 5.2 Adjustment of Supersonic Sensitivity
91
– The LED must go out.
Å If the switching point of the proximity switch amplifier is outside the selected range, correct it
accordingly.
2XWSXW&RQYH\RU
Å Slide the PCB over the proximity switch "Output conveyor".
Å Turn the adjusting screw of the proximity switch amplifier "Output conveyor" fully counterclock-
wise.
– The yellow LED of the amplifier begins to flash.
Å Slowly, turn the adjusting screw of the proximity switch amplifier to the right, until the LED light
remains illuminated.
Å Hold the PCB approximately 5 mm above the PCB conveyor.
– The LED must go out.
Å If the switching point of the proximity switch amplifier is outside the selected range, correct it
accordingly.
Å Use the instructions for the adjustment of the first conveyor to adjust the second conveyor ac-
cordingly.
5 Single and Dual PCB Conveyor Adjustment Instructions SIPLACE HS-50
5.3 Adjustment of Proximity Switches of Lifting Tables Edition 12/00
92
$GMXVWPHQWRI3UR[LPLW\6ZLWFKHVRI/LIWLQJ7DEOHV
Å Adjust the distance between the proximity switch and the sprocket wheel to 0.4 mm.
.(<
(1) Proximity switch, lifting table (2 pieces)
(7) Sprocket wheel lifting table
(A) Distance proximity switch sprocket wheel = 0.4 mm
Adjustment Instructions SIPLACE HS-50 5 Single and Dual PCB Conveyor
Edition 12/00 5.4 Adjustment of the Proximity Switches PCB Stopper
93
$GMXVWPHQWRIWKH3UR[LPLW\6ZLWFKHV3&%6WRS
SHU
Å Utilize the menu for the extraction of the PCB stopper.
6,7(67
Å Select "Transport functions" ==> "PCB conveyor 1 or 2" ==> "Stopper 1 (2)
retract / extract".
Å Carefully, move the proximity switch until contact is reached.
Å Pull back the proximity switch until a small gap of approximately 0.2 mm is reached, while the
contact must not get interrupted.