DEK INFINITY USER MANUAL.pdf.pdf - 第41页
INFINITY 0$&+,1 (352*5 $00,1* 67$*( %9$ &880722/,1 * Soft ware Ver sion 7 User Manual 1.39 49. Se lect Lower Head (F2). 50. Remove the Head Prop. 51. Se lect Confirm (F1). 52. Lower the printhead using two…
INFINITY
0$&+,1(352*5$00,1*
67$*(%9$&880722/,1*
1.38 User Manual Software Version 7
33.Fit the head prop.
34.Press Confirm (F1).
35.Check that the setup of the tooling is adequate for the board, adjust as
necessary.
36.Select Lower Head (F2).
37.Remove the Head Prop.
38.Select Confirm (F1).
39.Lower the printhead using two button control.
40.Close the front printhead cover.
41.Press the System button.
42.Select Home Position (F7).
43.Select Raise Head (F2).
44.Raise the printhead using two button control.
45.Fit the head prop.
46.Press Confirm (F1).
47.Select Board Clamps (F3) to open the clamps.
48.Remove the board from the rails.
Confirm
Lower
Head
Adjust
Lower
Head
Board
Clamps
Set
Stop
Confirm Cancel
Raise
Head
Home
Position
Exit
Adjust
Raise
Head
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
Confirm
Lower
Head
Adjust
Lower
Head
Board
Clamps
Set
Stop
INFINITY
0$&+,1(352*5$00,1*
67$*(%9$&880722/,1*
Software Version 7 User Manual 1.39
49.Select Lower Head (F2).
50.Remove the Head Prop.
51.Select Confirm (F1).
52.Lower the printhead using two button control.
53.Close the front printhead cover.
54.Press the System button.
55.Select Exit (F8).
56.Go to Stage 7.
Adjust
Lower
Head
Board
Clamps
Set
Stop
Confirm Cancel
Adjust
Raise
Head
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
INFINITY
0$&+,1(352*5$00,1*
67$*(&'(',&$7('722/,1*
1.40 User Manual Software Version 7
STAGE 6C - DEDICATED TOOLING
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
CAUTION
BOARD CLAMPS. Care must be taken to ensure that the board clamps
are not damaged when removing or replacing tooling.
1. Select Change Tooling (F6).
2. Select Full Width (F5). The message ‘Checking for a board on the belts’
is displayed. Whilst the rear rail is moving the following message ‘Rail
Moving...’ is displayed.
3. Select Raise Head (F2).
4. Raise the printhead using two button control.
The following window and menu bar is displayed:
Mode
Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
Adjust
Raise
Head
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
Adjust
Raise
Head
Remove
Cleaner
Board
Stop
Board
Width
Load
Width
Print
Height
Exit
Hazardous Operation
The head must be propped while it is
raised
Insert the Head Prop.
Confirm
Lower
Head