DEK INFINITY USER MANUAL.pdf.pdf - 第48页
INFINITY 0$&+,1( 352*5$ 00,1* 67$*(' 0 8/7,)/(;722/,1 * 1.46 User Manual Software Versi on 7 ST AGE 6D - MUL TIFLEX TO OLING W ARNIN G BOARD CLAMPS. EXTREME CAR E MUST BE EXERCISED WHEN WO RKING IN THE TO…
INFINITY
0$&+,1(352*5$00,1*
67$*(&'(',&$7('722/,1*
Software Version 7 User Manual 1.45
46.Raise the printhead using two button control.
47.Fit the head prop.
48.Press Confirm (F1).
49.Select Board Clamps (F3), to open the clamps.
50.Remove the board from the rails.
51.Select Lower Head (F2).
52.Remove the Head Prop.
53.Select Confirm (F1).
54.Lower the printhead using two button control.
55.Close the front printhead cover.
56.Press the System button.
57.Select Exit (F8).
58.Go to Stage 7.
Confirm
Lower
Head
Adjust
Lower
Head
Board
Clamps
Set
Stop
Adjust
Lower
Head
Board
Clamps
Set
Stop
Confirm Cancel
Adjust
Raise
Head
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
INFINITY
0$&+,1(352*5$00,1*
67$*('08/7,)/(;722/,1*
1.46 User Manual Software Version 7
STAGE 6D - MULTIFLEX TOOLING
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
CAUTION
BOARD CLAMPS. Care must be taken to ensure that the board clamps
are not damaged when removing or replacing tooling.
NOTE
Setting up the MultiFlex tooling is to be performed off the machine.
1. Create a box the same size as the board using the side plates.
2. Use the board width and board length dimensions to position the box
correctly.
3. Place the PCB on a flat surface, component side up.
4. Position the acetate template, supplied with the tooling, over the PCB such
that the front edge of the board is aligned with the arrow indicators on the
template. Ensure that the centreline of the board is aligned with the template
zero.
5. Using the grid co-ordinates marked on the template, position pins which
coincide with gaps between the underside board components.
INFINITY
0$&+,1(352*5$00,1*
67$*('08/7,)/(;722/,1*
Software Version 7 User Manual 1.47
6. Select Change Tooling (F6).
7. Select Full Width (F5). The message ‘Checking for a board on the belts’
is displayed. Whilst the rear rail is moving the following message ‘Rail
moving...’ is displayed.
8. Select Raise Head (F2).
9. Raise the printhead using two button control.
The following window and menu bar is displayed:
10.Fit the head prop.
Mode
Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
language
Exit
Adjust
Raise
Head
Remove
Cleaner
Board
Stop
Full
Width
Load
Width
Print
Height
Exit
Adjust
Raise
Head
Remove
Cleaner
Board
Stop
Board
Width
Load
Width
Print
Height
Exit
Hazardous Operation
The head must be propped while it is
raised
Insert the Head Prop.
Confirm
Lower
Head