4OM-1505-004_w.pdf - 第71页
4OM-1505 1-20 3. Maintenance Spots : Chap.1 Every 5 years Lubrication Squeegee Head Y -Axis Linear Guide (One each in front and rear) Inject new grease from the grease nipple with a grease gun. The used attachments shoul…
4OM-1505
1-19
3. Maintenance Spots : Chap.1
3.2.2 Squeegee Head Section
Squeegee
Every Day Cleaning
Clean the squeegees with a rag soaked
in industrial alcohol (solvent) or
directly with industrial alcohol
(solvent).
Remove deteriorated solder paste.
Front Side
F4A5
Stencil Recognition Lighting
Glass Surface
Every Month Cleaning
Remove dirt and dust, etc.,
with an air blow brush for camera.
Rear Side
Lens
Camera
Lighting
F4A6
0906-001
4OM-1505
1-20
3. Maintenance Spots : Chap.1
Every 5 years Lubrication
Squeegee Head Y-Axis Linear Guide
(One each in front and rear)
Inject new grease from the grease nipple
with a grease gun.
The used attachments should be
the U- and P-types or the SPK-3C.
Rear Side
Front Side
Note
Note
Note
Note
Note
If a large amount of grease is
applied, it may be dispersed
over a PCB and the stencil.
After applying grease, brush
the surface or scrape with a
spatula until a small amount
of grease remains on the
surface of the ball screw.
Every 5 years Lubrication
Squeegee Head Y-Axis Ball Screw
(Only on the right side)
Every Month Cleaning
Squeegee Head Y-Axis Linear
Guide (Right Side)
Do not leave any waste
threads after cleaning.
Every 5 years Lubrication
Squeegee Head Y-Axis Linear
Guide (Left Side)
Inject new grease from the grease
nipple with a grease gun.
The used attachments should
be the U- and P-types or the
SPK-3C.
Clean the stopper with an oiled rag.
Every Month Cleaning
Squeegee Head Y-Axis Linear
Guide (Left Side)
Do not leave any waste
threads after cleaning.
Apply grease with a brush or a
spatula.
Clean the stopper with an oiled rag.
F4A7
0906-001
4OM-1505
1-21
3. Maintenance Spots : Chap.1
Stencil Recognition X-Axis
Ball Screw
Every 6 Months Lubrication
Stencil Recognition X-Axis
Linear Guide
Every 5 years Lubrication
Apply grease with a brush or a
spatula.
Apply grease with a brush or a
spatula.
If a large amount of grease is
applied, it may be dispersed
over a PCB and the stencil.
After applying grease, brush
the surface or scrape with a
spatula until a small amount
of grease remains on the
surface of the ball screw.
Rear Side
Note
Clean the stopper with an oiled rag.
Every Month Cleaning
Stencil Recognition X-Axis
Linear Guide
Note
Do not leave any waste
threads after cleaning.
F4A8
Guide Bushing for Squeegee
Up/Down Movement
Every Month Cleaning
Clean the stopper with an oiled rag.
Do not leave any waste
threads after cleaning.
Guide Bushing for Squeegee
Up/Down Movement
Apply grease with a brush or a
spatula.
Every 6 Months Lubrication
Front Side
Note
F4A9
0906-001