4OM-1505-004_w.pdf - 第74页

4OM-1505 1-23 3. Maintenance Spots : Chap.1 Stencil Y -Axis Linear Guide Every Month Cleaning Clean the stopper with an oiled rag. Do not leave any waste threads after cleaning. Every 5 years Lubrication Stencil Y -Axis …

100%1 / 181
4OM-1505
1-22
3. Maintenance Spots : Chap.1
3.2.3 Stencil Holder Section
Upper Surface of Stencil Holder
Every Day Cleaning
Wipe off dirt and dust accumulated
on the upper and side surfaces
with a rag.
Stencil Printing Pattern
Every Day Cleaning
After using the stencil, use an
ultrasonic cleaner (industrial
alcohol solvent) to clean the stencil
such that the mesh (pores) of
the stencil (stencil patterns) is
not clogged.
Lower Surface of Stencil
Every Day Cleaning
Clean the lower surface of
the stencil with a rag soaked in
industrial alcohol (solvent).
Front Side
F4A10
0906-001
4OM-1505
1-23
3. Maintenance Spots : Chap.1
Stencil Y-Axis Linear Guide
Every Month Cleaning
Clean the stopper with an oiled rag.
Do not leave any waste
threads after cleaning.
Every 5 years Lubrication
Stencil Y-Axis Linear Guide
(Right Side)
Inject new grease from the grease
nipple with a grease gun or a brush.
The used attachments should
be the U- and P-types or the
SPK-3C.
If a large amount of grease is
applied, it may be dispersed
ver a PCB and the stencil.
After applying grease, brush
the surface or scrape with a
spatula until a small amount
of grease remains on the
surface of the ball screw.
Every 6 months Lubrication
Stencil Y-Axis Ball Screw
Apply grease with a brush.
Front Right Side
Front Right Side
Note
Note
Note
F4A11
Stencil Y-Axis Linear Guide
Every Month Cleaning
Clean the stopper with an oiled rag.
Every 5 years Lubrication
Stencil Y-Axis Linear Guide
(Left Side)
The used attachments should
be the U- and P-types or
the SPK-3C.
Inject new grease from the grease
nipple with a grease gun or a brush.
Front Left Side
Note
Do not leave any waste
threads after cleaning.
Note
F4A12
0906-001
4OM-1505
1-24
3. Maintenance Spots : Chap.1
3.2.4 PEC Recognition Section
　
　
PCB Stopper
PCB Warpage Top Holder
(Plunger End Section)
In the case that dust is attached
to the pressing surface, remove it.
Every Week Cleaning
Clean the stopper with an oiled rag.
Every Week Cleaning
Do not leave any waste
threads after cleaning.
Camera (Lens)
PEC Recognition Lighting Glass
Surface
Remove dirt and dust with an ari
blow brush for camera.
Every Month Cleaning
PEC Recognition X-Axis
Linear Guide
Every Month Cleaning
PEC Recognition X-Axis
Linear Guide
Apply grease with a brush or a
spatula.
Every 6 Months Lubrication
Clean the stopper with an oiled rag.
Do not leave any waste
threads after cleaning.
Note
Note
F4A13
1002-002