PCP-Manual-REV-C.pdf - 第22页

PCP Series Manual Revision B / October 2021 Page 22 of 56 5. Make sure all material is removed from the inside and outside of the st ator using a pipe cleaner. Figure 18 : Clean the Stator 6. Make sure material is remove…

100%1 / 56
PCP Series Manual
Revision B / October 2021
19. Separate the seal block from the rotor assembly.
Figure 16: Remove Seal Block
Clean All Wetted Parts
• Wear gloves when you use solvents.
• Cover the work surface so the solvent and material does not damage it.
• Only use appropriate solvents.
1. Use solvent, cotton tipped applicators and lint free disposable towels to clean all
wetted parts of the pump. When cotton tipped applicators and towels get dirt and
material on them, discard them and use a new one. Do not mix the materials.
2. Make sure all material is removed from the inside and outside.
3. Clean the fluid port.
4. Make sure all material is removed from the rotor and the groove at the base of the
rotor.
Figure 17: Clean Rotor
Note: Do not flush the rotor assembly with any material or put it in solvent as the
bearings may be damaged as a result. Clean only with cotton tipped applicators, a
cloth, and/or a soft brush.
PCP Series Manual
Revision B / October 2021
5. Make sure all material is removed from the inside and outside of the stator using a
pipe cleaner.
Figure 18: Clean the Stator
6. Make sure material is removed before assembling the pump.
7. Clean both the mix clip and manifold with solvent, cotton tipped applicators and lint
free disposal wipes.
PCP Series Manual
Revision B / October 2021
Assembly Instructions
Assemble the Pump
1. Install the seal block onto the rotor assembly.
Figure 19: Install Seal Block on Rotor Assembly
Note: When installed, the four small holes on the seal block should be facing away
from the rotor assembly. The side in the image below should be facing towards the
rotor assembly.
Figure 20: Seal Block Direction
2. Press the seal block and rotor assembly together. To avoid damage to the seals,
ensure that the seal block and rotor assembly are concentric.
Figure 21: Seal Block and Rotor Assembly