PCP-Manual-REV-C.pdf - 第24页
PCP Series Manual Revision B / October 2021 Page 24 of 56 3. Lubricate the AN016 O-ring with pump conditioner. 4. Install the AN016 O-ring onto the s eal block. Figure 22 : Install O-Ring on Seal Block 5. Install the flu…
PCP Series Manual
Revision B / October 2021
Page 23 of 56
Assembly Instructions
Assemble the Pump
1. Install the seal block onto the rotor assembly.
Figure 19: Install Seal Block on Rotor Assembly
Note: When installed, the four small holes on the seal block should be facing away
from the rotor assembly. The side in the image below should be facing towards the
rotor assembly.
Figure 20: Seal Block Direction
2. Press the seal block and rotor assembly together. To avoid damage to the seals,
ensure that the seal block and rotor assembly are concentric.
Figure 21: Seal Block and Rotor Assembly
PCP Series Manual
Revision B / October 2021
Page 24 of 56
3. Lubricate the AN016 O-ring with pump conditioner.
4. Install the AN016 O-ring onto the seal block.
Figure 22: Install O-Ring on Seal Block
5. Install the fluid block onto the seal block/rotor assembly.
Figure 23: Install Fluid Block
Note: When installing the fluid block, ensure that the bleed port is on the front and
the fluid inlet is on the outer side of the pump. For example, in the left pump pictured
above, the fluid inlet is on the left side.
Bleed Port
Fluid Inlet
PCP Series Manual
Revision B / October 2021
Page 25 of 56
Figure 24: Fluid Block Installed
6. Install the two M3 x 35 mm socket head cap screws onto the rotor assembly and
fluid block. Tighten with a 2.5 mm hex key.
Figure 25: Install Screws onto Rotor Assembly/Fluid Block
7. Lubricate the AS013 O-ring with pump conditioner.
8. Install the o-ring on the bottom of the fluid block assembly.
Figure 26: Install O-Ring on Fluid Block Assembly