OM-1754-001w_GS-F600.pdf - 第110页
OM-1754 3-12 1.4 "DVC Check" Submenu 1.4.1 "INP/OUT" Window This window enables the operator to check the I/O status in each section. "INP/OUT" window FC11 Reference Refer to "6.1 "…
OM-1754
3-111303-001
[3] "Information" Group Box
Displayed is the data of the multi-layer tray feeder that was used for the
previous adjustment.
The following items are displayed.
Elev No.
Draw Step No.
Cmp Hgt
Mag Type
Time
Note
The data being edited will not be displayed as information.
[4] Operational Object Selection Buttons
Select the object for the operation.
When pressed, this button moves the specied step to the traverse draw out
position.
[5] Operation Selection Buttons
[Pallet Chng Pos] Button
: When pressed, this button moves the
elevator to the component supply position.
[Mag Chng Pos] Button
: When pressed, this button moves the
elevator to the magazine change position.
[Pallet Draw Position] Button
: When pressed, this button moves the
elevator to the traverse draw out position.
[Zero] Button
: When pressed, this button zeros the
elevator.
[Rack Shtr Opn/Cls] Button
: When pressed, this button opens or closes
the rack shutter.
[Chuck Opn/Cls] Button
: When pressed, this button opens or closes
the chuck.
[Servo ON] Button
: When pressed, this button turns on the
power to the servomotor.
[Servo OFF] Button
: When pressed, this button turns off the
power to the servomotor.
[Up (Step)] Button
: When pressed, this button moves the
elevator upward by 1 pitch of the pallet.
[Down (Step)] Button
: When pressed, this button moves the
elevator downward by 1 pitch of the
pallet.
[Pallet Draw] Button
: When pressed, this button activates the
traverse to draw out the pallet.
[Pallet Storage] Button
: When pressed, this button stores the pallet
drawn out on the traverse.
1.3 "Unit Adj." Submenu
OM-1754
3-12
1.4 "DVC Check" Submenu
1.4.1 "INP/OUT" Window
This window enables the operator to check the I/O status in each section.
"INP/OUT" window FC11
Reference
Refer to "6.1 "INP/OUT" Window" in Chapter 1, Volume 3 for the details.
1303-001
Graphic
Development
1.4 "DVC Check" Submenu
OM-1754
3-131303-001
1.4.2 "MOTOR" Window
This window enables the operator to perform the manual alignment operation of
each unit and display the current system data.
"MOTOR" window FC12
Reference
Refer to "6.2 "MOTOR" Window" in Chapter 1, Volume 3 for the details.
1.4.3 "COM. STAT" Window
FC13
Graphic
Development
1.4 "DVC Check" Submenu