4OM-1050-002.pdf - 第28页

Fig. 4A14-1 Front View of Machine Component Receiving Box  1D8 Daily Cleaning Clean with a vacuum cleaner . 1.3 Maintenance Spots 0207-004 1-15 AFO01ETRP

(4) Component Recognition Section

(5) Main Section of Machine Intermediate Base/Component Receiving Box

Fig. 4A14

1.3 Maintenance Spots

0207-004 1-14 AFO01ETRP

Use a suction force (a vacuum cleaner) for cleaning.

Do not blow air with an air gun.

If the component recognition section is dirty or

dusty, incorrect recognition will result.

CAUTION

Fig. 4A13

Fig. 4A14-1 Front View of Machine

Component Receiving Box 1D8

Daily Cleaning

Clean with a vacuum cleaner.

1.3 Maintenance Spots

0207-004 1-15 AFO01ETRP

(6) Cutter Section Component Drop Prevention Cover

1.3 Maintenance Spots

0207-004 1-16 AFO01ETRP

Component Drop Prevention Cover 1D9

Daily Cleaning

When components are scattered over the

cover, follow the steps below to remove them.

1. Set the timing angle of the rotary turret to

approx. 200 degrees and turn off the power

supply before cleaning work.

2. Remove the four screws and pull out the

cover toward the rear side of the machine.

3. Clean the cover with a vacuum cleaner, etc.

4. Attach the cover to the machine such that

the rail section of the cover is correctly

inserted into the guide section of the machine.

5. Attach the four screws.

Pull out.

Guide Section

Screws

Rail Section

Screw

Fig. 4A15 Rear View of Machine